Owner's Manual

10
1� Remove the water tank, ll to the MAX line with fresh
water (g� 1A) then put back in the appliance (g� 1B)�
2� Place a container with a minimum capacity of 100 ml
under the cappuccino maker (g� 2)�
3� Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g� 3)�
4� The
light ashes on the control panel (g� 4)�
5� Turn the steam dial to the “I” position (g� 5)� The
appliance delivers water from the cappuccino maker then
goes o�
6� Turn the steam dial to the “0” position�
The coee maker is now ready for normal use�
Please note :
• When using the appliance for the rst time, you need to
make 4-5 cups of coee or 4-5 cappuccinos before the
appliance starts to give satisfactory results�
TURNING THE APPLIANCE ON
Please note :
• Before turning the appliance on, make sure the main
switch on the back of the appliance is in the I position (g�
3)�
• Each time the appliance is turned on, it performs an
automatic preheat and rinse cycle which cannot be
interrupted� The appliance is ready for use only after
completion of these cycles�
Danger Of burns!
During rinsing, a little hot water comes out of the coee spouts
and is collected in the drip tray underneath�
Avoid contact with splashes of water�
• To turn the appliance on, press the
(g� 6): The
corresponding
light ashes while the appliance is
heating up and performing an automatic rinse cycle (by
circulating hot water, the appliance heats both the boiler
and the internal circuits)�
The appliance is at temperature when the
light goes o and
the lights corresponding to the coee buttons come on�
TURNING THE APPLIANCE OFF
Each time the appliance is turned o, it performs an automatic
rinse cycle which cannot be interrupted�
Danger Of burns!
During rinsing, a little hot water ows from the coee spouts�
Avoid contact with splashes of water�
To turn the appliance o, press the
button (g� 6)� The
appliance performs a rinse cycle, then goes o�
Please note :
If the appliance is not used for an extended period, also place
the main switch in the 0 position (g� 3)�
Important!
To avoid damaging the appliance, do not place the main switch
(g� 3) in the 0 position until the appliance has been turned o
using the button�
AUTOOFF
The appliance is set to turn o automatically if not used for 2
hours�
The time can be changed so that the appliance switches o
after 15 or 30 minutes, or after 1, 2 or 3 hours�
The set the auto-o, proceed as follows:
1� With the machine o and the main switch in I position
(g� 3), press the
button and keep it pressed until the
lights on the control panel come on�
2� Press the button (on the left side of the dial) until
the lights corresponding to the number of hours before
the appliance goes o automatically come on:
15 minutes ECO
30 minutes ECO
1 hour ECO
2 hours ECO
3 hours ECO
3� Press the button (on the right side of the dial) to
conrm; the lights switch o�
ENERGY SAVING
Use this function to enable or disable energy saving mode�
When enabled, the function reduces energy consumption in
compliance with European regulations�
Energy saving mode is active when the green ECO light is on
(g� 7)�
1� With the appliance o and the main switch in the I
position (g� 3), press the
button and hold it down
until the ECO light comes on (g� 7)�
2� To disable the mode, press the button (on the left of
the dial)� The ECO light ashes�
3� To re-enable the mode, press the ECO button (on the left
of the dial) again� The ECO light comes on steadily�
4� Press the button (on the right of the dial) to