Operation Manual

18
12� Turn the steam knob and press the
button�
13� At the end of delivery, the light flashes�
Close the knob and the appliance returns au-
tomatically to the “ready for coffee” state�
The new filter is now active and you can use the
coffee maker�
Removing the filter
If you want to continue using the appliance with-
out a filter, you must remove it and notify the ap-
pliance of its removal as follows:
1� Extract the tank and exhausted filter;
2� Press the P button to enter the menu;
3� Turn the selection knob (fig� 8) until the
and lights come on;
4� Press the button� The OK light flashes;
5� Press the button to confirm use of the
appliance without the filter;
6� Press the button to exit the menu�
TECHNICAL SPECIFICATION
Voltage: 220-240 V~ 50/60 Hz max� 10A
Absorbed power: 1450W
Pressure: 15 bars
Water tank capacity: 1�8 L max�
Size LxHxD: 238x345x430 mm
Cable length: 1�15 m
Weight: 9�1 kg
Coffee beans container capacity: 250 g max�
The appliance complies with the following
EC directives:
• Stand-by Directive no. 1275/2008;
• Low Voltage Directive 2006/95/EC and sub-
sequent amendments;
• EMC Directive 2004/108/EC and subsequent
amendments
• Materials and accessories coming into con-
tact with food conform to EEC regulation
1935/2004�
DISPOSAL
Important information for correct dis-
posal of the product in accordance with
EC Directive 2002/96/EC�
At the end of its working life, the product
must not be disposed of as urban waste�
It must be taken to a special local authority dif-
air bubbles to escape (fig� 31)�
5� Insert the filter in the filter housing (fig� 32A)
and press as far as it will go�
6� Close the tank with the lid (fig� 32B), then
replace the tank in the machine�
When you install the filter, you must notify the
appliance of its presence�
7� Press the P button to enter the menu;
8� Turn the selection knob until the and
lights come on�
9� Press the OK button�
10� Press the button to confirm the selec-
tion�
11� Place a container (min� capacity: 100 ml) un-
der the cappuccino maker�
12� Turn the steam knob and press the but-
ton�
13� At the end of delivery, the light flashes�
Close the knob and the appliance returns au-
tomatically to the “ready for coffee” state�
The new filter is active and you can now use the
coffee maker�
Replacing the filter
When the light flashes, after two months
(see date indicator) or when the appliance has
not been used for 3 weeks, you should replace
the filter:
1� Remove the exhausted filter;
2� Remove the new filter from the packaging�
3� Turn the date indicator disk (see fig� 30) until
the next 2 months of use are displayed (the
filter lasts about two months);
4� Refill the tank;
5� Insert the filter in the water tank and im-
merse it completely, sloping it to enable the
air bubbles to escape (fig� 31);
6� Place the filter in the filter housing (fig� 32A)
and press as far as it will go� Close the tank
with the lid (fig� 32B), then replace the tank
in the machine;
7� Place a container (min� capacity: 100 ml) un-
der the cappuccino maker�
8� Press the P button to enter the menu;
9� Turn the selection knob until the and
lights come on�
10� Press the button� The OK light flashes�
11� Press the button to confirm the selec-
tion�