Instruction Manual

16
20. EXPLANATION OF LIGHTS
LIGHTS DISPLAYED POSSIBLE CAUSE REMEDY
FLASHING
The steam/hot water dial must be turned
(A21)
Turn the steam/hot water dial
FLASHING
Insucient water in the tank (A7) Fill the tank with water and/or insert it correctly,
pushing it as far as it will go until it clicks into
place.
ON
The tank (A7) is missing or not correctly
in place
Insert the tank correctly, pushing it as far as it
will go until it clicks into place.
FLASHING
The grounds container (A13) is full Empty the grounds container and drip tray (A14),
clean and replace. Important: when removing the
drip tray, the grounds container must always be
emptied, even if it has not lled up appreciably. If
this is not done, when you make the next coees,
the grounds container may ll up more than ex-
pected and clog the machine.
ON
After cleaning, the grounds container
(A13) has not been replaced
Remove the drip tray (A14) and insert the
grounds container.
FLASHING
The grinding is too ne and the coee is
delivered too slowly or not at all
Repeat coee delivery and turn the grinding
adjustment dial (A5) (g. 13) one click clockwise
towards "7" while the coee mill is in operation.
If after making at least 2 coees delivery is still
too slow, repeat the correction procedure, turn-
ing the grinding adjustment dial another click
until delivery is correct (see section “12.2 Adjust-
ing the coee mill”). If the problem persists, turn
the steam/hot water dial (A21) to the I position
and let some water run from the cappuccino
maker (A18).
If the water softener lter (C4) is present,
an air bubble may have been released in-
side the circuit, obstructing delivery
Deliver a little water from the cappuccino maker
(A18) by turning the steam/hot water dial (A21)
to the I position until the ow is regular (g. 5).
FLASHING
The coee beans have run out Fill the beans container (A3 - g. 14 ).
→