User Manual

22
Ground too ne
Adjust mill
The grinding is too ne and the coee is deliv-
ered too slowly or not at all.
Repeat coee delivery and turn the grinding
adjustment dial (A5) (g. 7) one click clockwise
towards 7 while the coee mill is in operation.
If after making at least 2 coees delivery is
still too slow, repeat the correction procedure,
turning the grinding adjustment dial another
click until delivery is correct (see section “10.1
Adjusting the coee mill”. If the problem per-
sists, make sure the water tank (A17) is fully
inserted.
If the water softener lter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the ow
becomes regular.
Less coee Too much coee has been used.
Select a lighter taste by pressing (B7) or
reduce the quantity of pre-ground coee.
Insert water spout The hot water spout (C6) is not inserted or is
inserted incorrectly.
Fully insert the hot water spout (g. 4).
Insert milk container The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (g.
16).
Insert infuser assembly The infuser (A20) has not been replaced after
cleaning.
Insert the infuser as described in section “14.9
Cleaning the infuser”.
Water circuit empty
Fill water circuit
Hot water
Conrm?
The water circuit is empty. Press OK (B3) to deliver water from the spout
(C6) until it ows out normally. If the problem
persists, make sure the water tank (A17) is fully
inserted.
Press OK to CLEAN The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
To proceed with the CLEAN function press OK
or turn the froth adjustment dial to another
position.
Set dial to CLEAN
ESC to cancel
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 19).
Turn froth adjustment dial The milk container (D) has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Turn the froth adjustment dial to one of the
milk froth positions.
Descale
ESC to cancel
OK to descale
(∼45 minutes)
The machine must be descaled. The descaling procedure described in section
“15. Descaling” needs to be performed.
Replace lter
ESC to cancel
OK to replace
The water softener lter (C4) is exhausted. Replace the lter or remove it as described in
section “17. Water softener lter”.
General alarm The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “14. Cleaning”. If the
message is still displayed after cleaning, con-
tact a service centre.