5713238071_00_0718 De’Longhi Appliances via Seitz, 47 31100 Treviso, Italy www.delonghi.
ECAM37X.95 BEAN TO CUP ESPRESSO AND CAPPUCCINO MACHINE Instruction for Use Instructions videos available at: http://ecam37095.delonghi.
EN page 6 B C B9 B1 B8 B7 D B2 PROFILE 1 B6 B3 B4 B4 B4 B4 B5 B5 C1 C6 C2 C5 C3 C4 D1 E D2 E1 E2 D4 D3 E5 D5 D6 E3 D7 2 E4
A1 A A2 A3 A5 A4 A6 A7 B C A22 A21 A8 A9 A10 A20 A19 A11 A12 A16 A13 A14 A17 A15 A18 3
1 2 3 4 5 6 7 8 9 10 11 12 15 16 MIL K 13 14 4
CLEAN 18 19 20 21 22 23 24 26 27 28 30 31 32 SH 17 PU S H PU 25A PU SH 25B 29 5
CONTENTS 1. INTRODUCTION............................................7 1.1 1.2 1.3 10. DELIVERING HOT WATER............................. 13 11. CUSTOMISING THE BEVERAGES ................... 13 12. MEMORISING YOUR OWN USER PROFILE...... 14 13. CLEANING.................................................. 14 Letters in brackets..................................................... 7 Troubleshooting and repairs..................................... 7 Download the App!...............................................
1. INTRODUCTION 2. DESCRIPTION Thank you for choosing this bean to cup espresso and cappuccino machine. Take a few minutes to read this Instruction for Use. This will avoid all risks and damage to the appliance. 1.1 Letters in brackets 1.2 Troubleshooting and repairs 1.3 Download the App! 2.1 Description of the appliance (page 3 - A) A1. Beans container lid A2. Pre-ground coffee funnel lid A3. Beans container A4. Pre-ground coffee funnel A5. Grinding adjustment dial A6. Cup shelf A7.
2.4 Description of the accessories (page 2 - D) D1. "Total Hardness Test" indicator paper (attached to page 2 of the English instructions) D2. Pre-ground coffee measure D3. Descaler D4. Water softener filter (certain models only) D5. Cleaning brush D6. Hot water spout D7. Power cord 2.5 E1. E2. E3. E4. E5. 3. Please note! • The first time you use the appliance, you need to make 4-5 cappuccinos before it starts to give satisfactory results.
6. MENU SETTINGS 6.1 Access the settings menu 6.2 Exit the menu 5. "CONFIRM RESET?": to confirm, press (to cancel, press ); 6. "VALORI FABBRICA""IMPOSTATI": press . The beverage has been reset to the default values. Proceed with the other beverages or go back to the homepage by pressing twice. 1. Press the " " button (C3) to enter the menu; 2. Scroll through the menu items by pressing until the required items is displayed; 3. Press the menu item you want to select.
2. Press the flag corresponding to the language you want to display all the languages to set (press available). 7. 6.12 Beep Important! Do not use green, caramelised or candied coffee beans as they could stick to the coffee mill and make it unusable. 1. Fill the container (A4) with coffee beans (fig. 10); 2. Place a cup under the coffee spouts (A9); 3. Lower the spouts as near as possible to the cup (fig. 11). This makes a creamier coffee; 4.
6. Preparation begins. An image of the selected beverage appears on the display, together with a progress bar which gradually fills as preparation proceeds. Once the coffee has been delivered, the machine will be ready for further use. LIGHT MEDIUM STRONG Important! Making LONG coffee: Halfway through preparation, the message "ADD GROUND COFFEE" "MAX. ONE MEASURE" is displayed. Add one level measure . of pre-ground coffee and press X-STRONG (see "7.
8.1 Filling and attaching the milk container • CAPPUCCINO MIX • CAFFELATTE • FLAT WHITE • ESPRESSO MACCHIATO 3. A message on the display instructs you to turn the froth adjustment dial (E1) according to the froth required by the original recipe. Turn the dial on the milk container lid. 4. After a few seconds, preparation begins automatically and an image of the selected beverage appears on the display, together with a progress bar which gradually fills as preparation progresses.
• • • Please note! • If "Energy Saving" mode is active, you may have to wait a few seconds before the hot water is delivered. • Preparation of hot water can be customised (see sections "11. Customising the beverages" and "12. Memorising your own user profile"). If you do not clean the milk container, the symbol appears on the display to remind you that it needs cleaning. The milk container can be kept in the refrigerator. In some cases, to clean you must wait for the appliance to heat up. 9.
ESPRESSO 40 ml 20-180 ml LONG 160 ml 115-250 ml COFFEE 180 ml 100-240 ml DOPPIO+ 120 ml 80-180 ml HOT WATER 250 ml 20-420 ml 12. • • 13.2 Cleaning the internal circuit If the appliance is not used for more than 3/4 days, before using it again, we strongly recommend switching it on and: • performing 2/3 rinse cycles by selecting the "Rinse" function (section "6.3 Rinse "); • delivering hot water for a few seconds (section "10. Delivering hot water").
To remove the drip tray, proceed as follows: 1. Remove the drip tray and coffee grounds container (A11) (fig. 22); 2. Remove the cup tray (A12) and drip tray grille (A14), then empty the drip tray and grounds container and wash all components. 3. Check the condensate tray (A15) (red) and empty if necessary; 4. Put the drip tray complete with grille and grounds container back in the appliance. 1. Make sure the machine is correctly turned off (see section "5. Turning the appliance off"); 2.
(one litre) up to level B and put the water tank back. Press ; 5. "EMPTY DRIP TRAY" (fig. 22): 6. Remove, empty and replace the drip tray (A15) and grounds container (A11). Press ; 7. "POSITION 2l CONTAINER" "OK TO START": Place an empty container with a minimum capacity of 2 litres under the hot water spout (D6) and coffee spouts (A9) (fig. 9); 6. Check that the intake tube and spout are not clogged with milk residues; 7.
16. "POSITION 2l CONTAINER" "OK TO START RINSING": Place the container used to collect the descaler solution empty under the hot water spout (fig. 9) and press 17. Hot water is delivered from the hot water/steam spout and "RINSING UNDERWAY" "PLEASE WAIT" is displayed; 18. "EMPTY DRIP TRAY" (fig. 22): At the end of the second rinse, remove, empty and replace the drip tray (A15) and ; grounds container (A11) and press 19. "DESCALE COMPLETE": press ; 20.
Please note IThe filter lasts about two months if the appliance is used normally. If the coffee machine is left unused with the filter installed, it will last a maximum of 3 weeks. 5. "RUN WATER INTO FILTER HOLE" "UNTIL IT COMES OUT" (fig. 38): To activate the filter, run tap water through the hole in the filter as shown in the figure until water comes out of the openings at the side for more than a minute. Press ; 6. Extract the tank (A17) from the appliance and fill with water. 7.
18. DISPLAYED MESSAGES DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY FILL TANK WITH FRESH WATER Insufficient water in the tank (A17). Fill the tank with water and/or insert it correctly, pushing it as far as it will go until it clicks into place. INSERT WATER TANK The tank (A17) is not correctly in place. Insert the tank correctly and press as far as it will go. EMPTY GROUNDS CONTAINER The grounds container (A11) is full.
DISPLAYED MESSAGE POSSIBLE CAUSE ADD GROUND COFFEE MAX. ONE MEASURE A LONG coffee with pre-ground coffee has been Place pre-ground coffee in the funnel (A4) (fig. requested 12) and press the selector corresponding to "OK" to continue and complete delivery. FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container (A4) (fig. 10). The pre-ground coffee funnel (A4) is clogged. Empty the funnel with the help of the brush (D5) as described in section "13.
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY INSERT WATER SPOUT The hot water spout (D6) is not inserted or is Insert the water spout as far as it will go. inserted incorrectly INSERT MILK CONTAINER The milk container (E) is not inserted correctly. INSERT INFUSER ASSEMBLY The infuser (A20) has not been replaced after Insert the infuser as described in section "13.9 cleaning. Cleaning the infuser".
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY PRESS OK TO CLEAN OR TURN DIAL The milk container has been inserted with To proceed with the CLEAN function, press the the froth adjustment dial (E1) in the CLEAN selector corresponding to "OK", or turn the froth adjustment dial to one of the milk positions. position. : TURN MILK FROTH ADJUSTMENT DIAL TO CLEAN POSITION Milk has been delivered recently and the tubes Turn the froth adjustment dial (E1) to CLEAN inside the milk container (E) must be cleaned. (fig.
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY GENERAL ALARM: REFER TO USER MANUAL / APP The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in section "13. Cleaning". If the message is still displayed after cleaning, contact a customer service centre. The tubes inside the milk container (E) must be Turn the froth adjustment dial (E1) to CLEAN cleaned. (fig. 19). Reminds you the filter (D7) must be replaced.
19. TROUBLESHOOTING Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Services. PROBLEM POSSIBLE CAUSE REMEDY The coffee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot water (Please note: you can use the hot water function). The infuser has cooled down because Before making the coffee, heat the infuser by 2/3 minutes have elapsed since the last rinsing using the rinse function (see section "6.
PROBLEM POSSIBLE CAUSE REMEDY At the end of descaling, the appliance During the two rinse cycles, the water Follow the instructions displayed by the applirequests a third rinse tank (A17) has not been filled to the ance, but first empty the drip tray (A15) to avoid the water overflowing. MAX level Milk does not flow from the milk The milk container (E) lid (E2) is dirty spout (E5) Clean the milk container lid as described in section "13.10 Cleaning the milk container".