Instruction Manual

16
34
8. Once inserted, make sure the two red buttons have
snapped out (g. 35).
35
PUSH
9. Close the infuser door.
10. Replace the water tank.
DESCALING
Descale the machine when the message “DESCALE” ashes on
the display.
Important!
• Descaler contains acids which may irritate the skin and
eyes. It is vital to respect the manufacturer’s safety warn-
ings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
• You should use De’Longhi descaler only.
Using unsuitable descaler and/or performing descaling
incorrectly may result in faults not covered by the manu-
facturer’s guarantee.
1. Turn the machine on.
2. Press the MENU/ESC button to enter the menu.
3. Press < or > until “Descale” is displayed.
4. Select by pressing the button: Conrm? is dis-
played. Press the button to conrm.
5. “EMPTY THE DRIP TRAY” is displayed, alternating with “RE-
MOVE FILTER” (if the lter is featured) and “ADD DESCALER,
PRESS OK”.
6. Empty the water tank (A18) completely and remove the
water softener lter (if present). Empty the drip tray (g.
26) and grounds container, then put them back in the
appliance.
B
A
A B
36
7. Pour the descaler into the
tank up to level A (corre-
sponding to a 100 ml
pack) marked on the back
of the tank (g. 36), then
add water (1 litre) up to
level B (g. 36) and put
the water tank back.
8. Place an empty container
with a minimum capacity
of 1.5 litres under the hot
water spout (g. 7).
Important! Danger of burns
Hot water containing acid ows out of the hot water spout.
Avoid contact with splashes of water.
9. Press the button to conrm that you have added
the solution. The descale programme automatically per-
forms a series of rinses and pauses to remove limescale
deposits from inside the machine.
“Descale underway” is displayed
The descale programme starts, and descaler comes out of
the water spout.
After about 30 minutes, the message “RINSING, INSERT FILTER”
(if removed previously) is displayed, alternating with “FILL
TANK”.
10. The appliance is now ready for rinsing through with clean
water. Extract the water tank, empty, rinse under running
water, ll with clean water up to the MAX level, insert the
lter (if removed previously) and put the water tank back
in the machine. “RINSING, Press OK “ is displayed.
11. Empty the container used to collect the descaler solution
and replace it empty under the hot water spout.
12. Press the button to start rinsing. Hot water ows
out of the spout and the message “RINSING, Please wait” is
displayed.
13. When the water tank is completely empty, the message
“Rinsing complete, Press OK” is displayed.
14. Press the button.
15. “Heating up Please wait” is displayed, at the end of which
the machine will be ready for use.
SETTING WATER HARDNESS
The DESCALE message is displayed after a period of time estab-
lished according to water hardness.
The machine is set by default for a hardness value of 4.
The machine can also be programmed according to the hardness
of the mains water in the various regions so that the machine
needs to be descaled less often.