Instruction Manual

20
GENERAL ALARM The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in the section “Cleaning”.
If the message is still displayed after cleaning,
contact a service centre.
EMPTY CIRCUIT, FILL CIRCUIT
HOT WATER
PRESS OK
The water circuit is empty
Press to deliver water from the
cappuccino maker (A10) until it ows out
normally.
REPLACE FILTER The water softener lter is exhausted. Replace the lter or remove it as described in
the section “Water softener lter”.
TROUBLESHOOTING
The water softener lter is exhausted.
Replace the lter or remove it as described in the section “Water softener lter”.
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot. The cups were not preheated. Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
The infuser has cooled down because
2/3 minutes have elapsed since the last
coee was made.
Before making coee, use the special function
to rinse and heat the infuser (page 10) .
A low coee temperature is set. Set a higher coee temperature in the menu
(page 11).
The coee is weak or not creamy
enough.
The coee is ground too coarsely. Turn the grinding adjustment dial one click
anticlockwise towards “1” while the coee mill
is in operation (g. 13). Continue one click at
a time until coee delivery is satisfactory. The
eect is only visible after delivering 2 coees
(see the section: “Adjusting the coee mill” on
page 12).
The coee is unsuitable. Use pre-ground coee for espresso machines.
The coee is delivered too slowly or a
drop at a time.
The coee is ground too nely. Turn the grinding adjustment dial one click
clockwise towards “7” while the coee mill is in
operation (g. 13). Continue one click at a time
until coee delivery is satisfactory.
The eect is only visible after delivering 2 cof-
fees (see the section: “Adjusting the coee mill”
on page 12 ).
Coee does not come out of one of the
spouts.
The spouts are blocked. Clean the spouts with a toothpick (g. 30).
The milk is not frothed Cappuccino maker dirty. Clean the cappuccino maker as described in the
corresponding section (page 14) .
The ring on the cappuccino maker is in
the “LATTE” position.
Push the ring into the “CAPPUCCINO” position.