Instruction Manual

17
14.6 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid. Rinse thoroughly before lling the tank and putting
it back in the appliance;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank;
4. (Models with water softener lter only) Deliver about
100ml of hot water to reactivate the lter.
14.7 Cleaning the coee spouts
1. Clean the coee spouts (A8) regularly with a sponge or
cloth (g. 28A);
2. Check that the holes in the coee spouts are not blocked.
If necessary, remove coee deposits with a toothpick (g.
28B).
14.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground
coee funnel (A4) is not blocked. If necessary, remove coee
deposits with the brush (C5) supplied.
14.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“5. Turning the appliance o”);
2. Remove the water tank (A16) (g. 3);
3. Open the infuser door (A18) (g. 29) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 30);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 31), then push the PUSH symbol fully
in until it clicks into place;
Please note!
33
PUSH
If the infuser is dicult to in-
sert, before insertion, adapt it
to the right size by pressing
the two levers shown in g.
32.
8. Once inserted, make sure
the two coloured buttons
have snapped out (g.
33);
9. Close the infuser door;
10. Put the water tank back .
14.10 Cleaning the milk container
To keep the frother ecient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (g. 34);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (g. 34) and pull it o upwards;
34
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dish-
washer safe, placing them in the top basket of the
dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (g. 35). If necessary, scrape the
groove with a toothpick;