Instruction Manual

18
35 36
5. Rinse inside the froth adjustment dial seat with running
water (g. 36);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
14.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A9)
with a sponge to remove milk residues from the gaskets (g.
22).
15. DESCALING
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
Descale the appliance when "DESCALING NEEDED - PRESS OK TO
START (~45min) " appears on the display (B1): To descale
the appliance immediately, press the corresponding selector
(B2) " OK" and follow the instructions from point 3.
To descale the appliance later, press the selector (B2) corre-
sponding to " ESC". The symbol appears on the display
to remind you that the appliance needs descaling. (the message
appears each time you turn the appliance on).
To access the descaling menu:
1. Press the selector (B2) corresponding to the " " symbol
(B5) to enter the menu;
2. Press the selector corresponding to " DESCALE" and fol-
low the instructions on the display;
37
38
A
B
A B
+
39
3. "REMOVE WATER SOF-
TENER FILTER" (g. 37):
extract the water tank
(A16), remove the water
softener lter (C4) (if
present) and empty the
water tank. Press the se-
lector corresponding to
“NEXT>”;
4. "DESCALER (LEVEL A)
AND WATER (LEVEL B)"
(g. 38); Pour the des-
caler into the tank up to
the level A marked inside
the tank (equal to one
100 ml pack), then add
water (one litre) up to
level B and put the water
tank back. Press the se-
lector corresponding to
“NEXT>”;
5. "EMPTY DRIP TRAY" (g.
39):
6. Remove, empty and re-
place the drip tray (A14)
and grounds container
(A10). Press the selec-
tor corresponding to
“NEXT>”;
7. "POSITION 2l CONTAINER
OK TO START":
Place an empty container with
a minimum capacity of 2 litres
under the hot water/steam
spout (C6) and coee spouts
(A8) (g. 8);
Important! Danger of burns
Hot water containing acid ows from the hot water/steam and
coee spouts. Take care to avoid contact with splashes of this
solution.
7. Press the selector corresponding to " OK" to conrm
that you have added the descaling solution. "DESCALING
UNDERWAY, PLEASE WAIT" is displayed: The descale pro-
gramme starts and the descaler liquid comes out of the
hot water and coee spouts. A series of rinses is performed
automatically to remove all the scale residues inside the
coee machine;
After about 25 minutes, descaling stops;