Instruction Manual

20
4. Press the selector corresponding to " ESC" to go back to
the homepage.
The machine is now reprogrammed with the new water hard-
ness setting.
17. WATER SOFTENER FILTER
Certain models are tted with a water softener lter (C4). If this
is not the case with your model, you are recommended to pur-
chase one from De’Longhi Customer Services.
To use the lter correctly, follow the instructions below.
17.1 Installing the lter
1. Remove the lter (C4)
from the packaging;
2. Press the selector (B2)
corresponding to the "
" symbol (B5) to
enter the menu;
3. Scroll through the menu
items by pressing the
selector corresponding to
"NEXT>" until " WATER
FILTER" appears on the
display;
4. Press the selector cor-
responding to " WATER
FILTER";
5. "TURN DATE INDICATOR TO NEXT 2 MONTHS" (g. 41):
turn the date indicator disk until the next two months
of use are displayed. Press the selector corresponding to
"NEXT>
;
Please note
IThe lter lasts about two months if the appliance is used nor-
mally. If the coee machine is left unused with the lter in-
stalled, it will last a maximum of 3 weeks.
42
6. "RUN WATER INTO FILTER
HOLE UNTIL IT COMES
OUT" (g. 42): To activate
the lter, run tap water
through the hole in the
lter as shown in the
gure until water comes
out of the openings at
the side for more than
a minute. Press the se-
lector corresponding to
NEXT>
;
7. Extract the tank (A16) from the appliance and ll with
water.
43
8. "IMMERSE FILTER TO
EXPEL AIR BUBBLES" (g.
43): Insert the lter in the
water tank and immerse
it completely for about
ten seconds, sloping it
and pressing it lightly to
enable the air bubbles
to escape. Press the se-
lector corresponding to
NEXT>
;
9. "INSERT FILTER IN HOUSING": Insert the lter in the lter
housing (A17-g. 40) and press as far as it will go. Press the
selector corresponding to "NEXT>;
10. "INSERT WATER TANK": Close the tank with the lid (A15),
then put the tank back in the machine (g. 6);
11. "POSITION 0.5L CONTAINER, PRESS OK TO ENABLE FIL
TER" (g. 8): Place the container under the hot water/
steam spout (C6) and press
" OK". Delivery begins and
stops automatically.
The lter is now active and you can use the coee machine.
17.2 Replacing the lter
Replace the lter (C4) when " REPLACE WATER FILTER,
PRESS OK TO START" appears on the display (B1): To replace the
lter immediately, press the selector (B2) corresponding to "
OK" and follow the instructions from point 5.
To replace the lter later, press the selector corresponding to "
ESC". The symbol appears on the display to remind
you that the lter needs replacing. To replace, proceed as
follows:
1. Extract the tank (A16) and exhausted lter;
2. Remove the new lter from the packaging;
3. Press the selector (B2) corresponding to the " " symbol
(B5) to enter the menu;
4. Press the selector corresponding to WATER FILTER”;
5. Press the selector corresponding to " REPLACE WATER
FILTER;";
6. Follow the operations described in the previous section
from point 5.
The lter is now active and you can use the coee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.