Instruction Manual
21
17.3 Removing the lter
If you want to use the appliance without the lter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A16) and exhausted lter;
2. Press the selector (B2) corresponding to the " " symbol
(B5) to enter the menu;
3. Press the selector corresponding to “ WATER FILTER”;
4. Press the selector corresponding to “ REMOVE WATER
FILTER”;
5. “ CONFIRM FILTER REMOVAL": to conrm press
the selector corresponding to " OK"
(to go back to the
settings menu,
press the selector corresponding to "
ESC")
;
6. " FILTER REMOVED": the change has been saved.
Press
" OK" to go back to the homepage.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
18. TECHNICAL DATA
Voltage: 220-240 V~ 50-60 Hz max. 10 A
Power: 1450 W
Pressure: 1.9 MPa (19 bars)
Water tank capacity: 2 l
Size LxDxH: 260x470x360 mm
Cord length: 1750 mm
Weight: 11.4 kg
Beans container capacity: 380 g
19. DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK WITH FRESH
WATER
Insucient water in the tank
(A16)
. Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place.
INSERT WATER TANK The tank
(A16)
is not correctly in place. Insert the tank correctly and press as far as it
will go.