Instruction Manual

DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY

GROUND TOO FINE. ADJUST

MILL

ESC

The grinding is too ne and the coee is deliv-

ered too slowly or not at all.

Repeat coee delivery and turn the grinding

adjustment dial

(A5) (g. 10)

one click clock-

wise towards 7 while the coee mill is in

operation. If after making at least 2 coees

delivery is still too slow, repeat the correction

procedure, turning the grinding adjustment

dial another click until delivery is correct (see

section “7.5 Adjusting the coee mill”

)

. If the

problem persists, make sure the water tank

(A16) is fully inserted.

If the water softener lter (C4) is present, an

air bubble may have been released inside the

circuit, obstructing delivery.

Insert the hot water/steam spout (C6) in the

appliance and deliver a little water until the

ow becomes regular.

SELECT A MILDER TASTE OR

REDUCE COFFEE AMOUNT

ESC

Too much coee has been used. Select a milder taste by pressing the selector

(B2) corresponding to "AROMA" (B10) or re-

duce the quantity of ground coee (maximum

1 measure).

INSERT WATER SPOUT The hot water spout (C6) is not inserted or is

inserted incorrectly

Insert the water spout as far as it will go.

INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container as far as it will go

(g.

18)

INSERT INFUSER ASSEMBLY The infuser (

A19

) has not been replaced after

cleaning.

Insert the infuser as described in section “14.9

Cleaning the infuser”.