Instruction Manual

24
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
WATER CIRCUIT EMPTY
PRESS OK TO START
OK
The water circuit is empty
Press the selector corresponding to " OK" to
deliver water from the spout ( C6) until it ows
out normally.
If the problem persists, make sure the water
tank (A16) is fully inserted.
PRESS OK TO CLEAN OR TURN
DIAL
OK
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
To proceed with the CLEAN function, press
the selector corresponding to " OK", or turn
the froth adjustment dial to one of the milk
positions.
TURN DIAL TO CLEAN POSITION
CLEAN
ESC
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 20).
TURN FROTH ADJUSTMENT
DIAL
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Turn the dial to the required froth position.
DESCALING NEEDED
PRESS OK TO START
~45MIN
ESC OK
The machine must be descaled.
Press the selector corresponding to " OK" to
start descaling or " ESC" to descale later.
The descaling procedure described in section
“15. Descaling” needs to be performed.