Instruction Manual

25
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
REPLACE WATER FILTER
PRESS OK TO START
ESC OK
The water softener lter (C4) is exhausted.
Press the selector corresponding to “ OK” to
replace or remove the lter, or ESC to carry out
the procedure later. Follow the instructions in
section “17. Water softener lter”.
GENERAL ALARM: USER
MANUAL / APP
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “14. Cleaning”. If the
message is still displayed after cleaning, con-
tact a customer service centre.
The appliance needs descaling and/or the lter
(C4) must be replaced.
The descaling procedure described in section
“15. Descaling” needs to be performed and/
or the lter needs replacing or removing as
described in section “17. Water softener lter”.
The tubes inside the milk container (D) must
be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 20).
The lter (C4) must be replaced. Replace the lter or remove it as described in
section “17. Water softener lter”.
The machine must be descaled. The descaling procedure described in section
“15. Descaling” needs to be performed.
• The appliance may request descaling cycles at
very short intervals. This is normal and due to
the appliance’s advanced control system.
Energy saving is enabled. To disable energy saving, proceed as described
in section “6.6 Energy saving ”.
The appliance is connected to a device via
bluetooth.
CLEANING UNDERWAY
PLEASE WAIT
The appliance has detected impurities in its
internal circuits.
Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.