Instruction Manual

12
• As soon as delivery has ended, to increase the quantity of
coee in the cup, just press the selector (B2) correspond-
ing to " EXTRA". When the required quantity is reached,
press the selector corresponding to " STOP".
Once the coee has been made, the appliance is ready to make
the next beverage.
Please note!
• Various alarm messages could be displayed while using
the appliance (FILL TANK, EMPTY GROUNDS CONTAINER,
ETC.). Their meaning is explained in section “20. Displayed
messages”.
• For hotter coee, see section “7.6 Tips for a hotter coee”.
• If the coee is delivered a drop at a time, too weak and not
creamy enough or too cold, read the tips in section “7.5 Ad-
justing the coee mill” and section “21. Troubleshooting”.
• Preparation of each coee can be customised (see sec-
tions”12. Customising the beverages ” and “13. Memoris-
ing your personal prole”).
• If "Energy Saving" mode is active, you may have to wait a
few seconds before the rst coee is delivered
7.4 Making coee using pre-ground coee
Important!
• Never add pre-ground coee when the machine is o or it
could spread through the inside of the machine and dirty
it. This could damage the appliance.
• Never use more than 1 level measure (C2) or it could dirty
the inside of the coee machine or block the funnel (A4).
• If you use pre-ground coee, you can only make one cup of
coee at a time.
1. Press the selector (B2) corresponding to "AROMA" (B10)
until " " (ground) appears on the display (B1).
2. Open the pre-ground coee funnel lid (A2).
3. Make sure the funnel (A4) is not blocked, then add one
level measure of pre-ground coee (g. 13).
4. Place a cup under the coee spouts (A8) (g. 12).
5. Then select your required coee:
Directly selected beverages:
- ESPRESSO (B7)
 COFFEE B8
 LONG B9
Selectable from the beverage selection menu (B3):
 AMERICANO
6. Preparation begins. An image of the selected beverage
appears on the display, together with a progress bar which
gradually lls as preparation proceeds.
Please note:
• While the machine is making coee, delivery can be inter-
rupted at any moment by pressing the selector (B2) corre-
sponding to " STOP".
• As soon as delivery has ended, to increase the quantity of
coee in the cup, just press the selector (B2) correspond-
ing to " EXTRA". When the required quantity is reached,
press the selector corresponding to " STOP".
Once the coee has been made, the appliance is ready to make
the next beverage.
Important! Making LONG coee:
Halfway through preparation, the message "ADD GROUND
COFFEE, MAXIMUM ONE MEASURE" is displayed. Add one level
measure of pre-ground coee and press the selector (B2) corre-
sponding to " OK".
Please note!
• Various alarm messages could be displayed while using
the appliance (FILL TANK, EMPTY GROUNDS CONTAINER,
ETC.). Their meaning is explained in section “20. Displayed
messages”.
• For hotter coee, see section “7.6 Tips for a hotter coee”.
• If "Energy Saving" mode is active, you may have to wait a
few seconds before the rst coee is delivered.
7.5 Adjusting the coee mill
The coee mill is set by default to prepare coee correctly and
should not require regulating initially.
However, if after making the rst few coees you nd that the
coee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by adjusting
the grinding adjustment dial (A5) (g. 10).
Please note!
The grinding adjustment dial must only be turned when the
coee mill is in operation during the initial phase of coee
preparation.
If the coee is delivered too slowly or not
at all, turn one click clockwise towards 7.
For fuller bodied creamier coee, turn
one click anticlockwise towards 1 (do
not turn more than one click at a time
otherwise the coee could be delivered
a drop at a time).
These adjustments will only be evident after at least 2 cups of
coee have been delivered. If this adjustment does not obtain
the desired result, turn the dial another click.
7.6 Tips for a hotter coee
For hotter coee, you should:
• perform a rinse cycle by selecting the "Rinsing" function in
the settings menu (section “6.1 Rinsing ”);
• warm the cups with hot water using the hot water function
(see section”9. Delivering hot water”);
• increase the coee temperature in the settings menu
" " (B5) (see section “6.7 Coee temperature ”).