Instruction Manual
15
12. CLEANING
12.1 Cleaning the machine
The following parts of the machine must be cleaned regularly:
- the appliance’s internal circuit;
- coee grounds container (A10);
- drip tray (A14), condensate tray (A22) and drip tray grille
(A13);
- water tank (A16);
- coee spouts (A8);
- pre-ground coee funnel (A4);
- infuser (A19), accessible after opening the infuser door
(A18);
- milk container (D);
- hot water connection nozzle (A9);
- control panel (B).
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coee machine. With De’Longhi superautomatic coee
machines, you need not use chemical products to clean the
machine.
• None of the components of the appliance can be washed
in a dishwasher with the exception of the drip tray grille
(A13) and milk container (D).
• Do not use metal objects to remove encrustations or coee
deposits as they could scratch metal or plastic surfaces.
12.2 Cleaning the machine's internal circuit
If the appliance is not used for more than 3/4 days, before using
it again, we strongly recommend switching it on and:
• performing 2/3 rinse cycles by selecting the "Rinse" func-
tion (section “6.1 Rinsing ”);
• delivering hot water for a few seconds (section “9. Deliver-
ing hot water”).
Please note!
After cleaning, it is normal for the grounds container (A10) to
contain water.
12.3 Cleaning the coee grounds container
When "EMPTY GROUNDS CONTAINER" appears on the display
(B1), the grounds container must be emptied and cleaned. The
appliance cannot be used to make coee until you have cleaned
the grounds container (A10). Even if not full, the empty grounds
container message appears on the display 72 hours after the
rst coee has been prepared. For the 72 hours to be calculated
correctly, the machine must never be turned o with the main
switch (A21).
Important! Danger of burns
If you make a number of cappuccinos one after the other, the
metal cup tray (A11) becomes hot. Wait for it to cool down be-
fore touching it and handle it from the front only.
To clean (with the machine on):
• Remove the drip tray (A14) (g. 23), empty and clean.
• Empty the grounds container (A10) and clean thoroughly
to remove all residues left on the bottom. This can be done
using the spatula on the brush (C5) provided.
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds. If this is not done,
when you make the next coees, the grounds container may ll
up more than expected and clog the machine.
12.4 Cleaning the drip tray and condensate tray
Important!
The drip tray (A14) is tted with a level indicator (A12) (red)
showing the level of water it contains (g. 24). Before the in-
dicator protrudes from the cup tray (A11), the drip tray must
be emptied and cleaned otherwise the water may overow the
edge and damage the appliance, the surface it rests on or the
surrounding area.
To remove the drip tray, proceed as follows:
1. Remove the drip tray and the coee grounds container
(A10) (g. 23);
2. Remove the cup tray (A11) and drip tray grille (A13), then
empty the drip tray and grounds container and wash all
components.
3. Check the red condensate tray (A22) and empty if
necessary.
4. Put the drip tray complete with grille and grounds contain-
er back in the appliance.
12.5 Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see section “5. Turning the appliance o”) and unplugged from
the mains power supply. Never immerse the coee machine in
water.
1. Check regularly (about once a month) that the inside of the
appliance (accessible after removing the drip tray - A14)
is not dirty. If necessary, remove coee deposits with the
brush (C5) supplied and a sponge.
2. Remove all the residues with a vacuum cleaner (g. 25).
12.6 Cleaning the water tank
1.
Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid. Rinse thoroughly before lling the tank and putting
it back in the appliance;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank;