Instruction Manual

16
4. (Models with water softener lter only) Deliver about
100ml of hot water to reactivate the lter.
12.7 Cleaning the coee spouts
1. Clean the coee spouts (A8) regularly with a sponge or
cloth (g. 26A);
2. Check that the holes in the coee spouts are not blocked.
If necessary, remove coee deposits with a toothpick (g.
26B).
12.8 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground
coee funnel (A4) is not blocked. If necessary, remove coee
deposits with the brush (C5) supplied.
12.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see section
“5. Turning the appliance o”);
2. Remove the water tank (A16) (g. 3);
3. Open the infuser door (A18) (g. 27) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 28);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged. 6. Use the brush (C5) to re-
move any coee residues left in the infuser housing, visible
through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (g. 29), then push the PUSH symbol fully
in until it clicks into place;
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 30.
8. Once inserted, make sure the two coloured buttons have
snapped out (g. 31);
9. Close the infuser door;
10. Put the water tank back.
12.10 Cleaning the milk container
To keep the frother ecient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (g. 33);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (g. 33) and pull o upwards;
33
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dish-
washer safe, placing them in the top basket of the
dishwasher.
Make sure there are no milk
residues on the hollow and
groove under the dial (g.
32). If necessary, scrape the
groove with a toothpick;
5. Rinse inside the froth
adjustment dial seat with
running water (g. 34);
6. Check that the intake
tube and spout are
not clogged with milk
residues;
7. Replace the dial (in correspondence to the word "INSERT"),
spout and milk intake tube;
8. Place the lid back on the milk container (D3).
12.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A9)
with a sponge to remove milk residues from the gaskets (g.
22).
13. DESCALING
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
34