Instruction Manual

19
40
6. "RUN WATER INTO FILTER
HOLE UNTIL IT COMES
OUT" (g. 40): To activate
the lter, run tap water
through the hole in the
lter as shown in the
gure until water comes
out of the openings at
the side for more than
a minute. Press the se-
lector corresponding to
“ NEXT> ” ;
7. Extract the tank (A16) from the appliance and ll with
water.
41
8. "IMMERSE FILTER TO
EXPEL AIR BUBBLES" (g.
41): Insert the lter in the
water tank and immerse
it completely for about
ten seconds, sloping it
and pressing it lightly to
enable the air bubbles
to escape. Press the se-
lector corresponding to
“ NEXT> ” ;
9. "INSERT FILTER IN
HOUSING": Insert the lter in
the lter housing (A17-g. 38) and press as far as it will go.
Press the selector corresponding to "NEXT>;
10. "INSERT WATER TANK": Close the tank with the lid (A15),
then put the tank back in the machine (g. 6);
11. "POSITION 0.5L CONTAINER, PRESS OK TO ENABLE FIL
TER" (g. 8): Place the container under the hot water
spout (C6) and press " OK ". Delivery begins and stops
automatically.
The lter is now active and you can use the coee machine.
15.2 Replacing the lter
Replace the lter (C4) when " REPLACE WATER FILTER,
PRESS OK TO START" appears on the display (B1): To replace the
lter immediately, press the selector (B2) corresponding to "
OK" and follow the instructions from point 5.
To replace the lter later, press the selector corresponding to "
ESC". The symbol appears on the display to remind
you that the lter needs replacing. To replace, proceed as
follows:
1. Extract the tank (A16) and exhausted lter;
2. Remove the new lter from the packaging;
3. Press the selector (B2) corresponding to the " " symbol
(B5) to enter the menu;
4. Press the selector corresponding to “ WATER FILTER”;
5. Press the selector corresponding to " REPLACE WATER
FILTER;";
6. Follow the operations described in the previous section
from point 5.
The lter is now active and you can use the coee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
15.3 Removing the lter
If you want to use the appliance without the lter (C4), you
must remove it and notify the appliance of its removal. Proceed
as follows:
1. Extract the tank (A16) and exhausted lter;
2. Press the selector (B2) corresponding to the " " symbol
(B5) to enter the menu;
3. Press the selector corresponding to “ WATER FILTER”;
4. Press the selector corresponding to “ REMOVE WATER
FILTER”;
5. “ CONFIRM FILTER REMOVAL": to conrm press the
selector corresponding to " OK" (to go back to the set-
tings menu, press the selector corresponding to " ESC") ;
6. " FILTER REMOVED": the change has been saved.
Press " OK" to go back to the homepage.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
16. TECHNICAL DATA
Voltage: 220-240 V~ 50-60 Hz max. 10 A
Power: 1450 W
Pressure: 1.9 MPa (19 bars)
Water tank capacity: 2 l
Size LxDxH: 260x470x360 mm
Cord length: 1750 mm
Weight: 11 kg
Beans container capacity: 380 g