Instruction Manual

22
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
INSERT WATER SPOUT The hot water spout (C6) is not inserted or is
inserted incorrectly
Insert the water spout as far as it will go.
INSERT MILK CONTAINER The milk container (D) is not inserted correctly. Insert the milk container as far as it will go (g.
18) .
INSERT INFUSER ASSEMBLY The infuser ( A19 ) has not been replaced after
cleaning.
Insert the infuser as described in section “12.9
Cleaning the infuser”.
WATER CIRCUIT EMPTY
PRESS OK TO START
OK
The water circuit is empty
Press the selector corresponding to " OK" to
deliver water from the spout ( C6) until it ows
out normally.
If the problem persists, make sure the water
tank (A16) is fully inserted.
PRESS OK TO CLEAN OR TURN
DIAL
OK
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
To proceed with the CLEAN function, press
the selector corresponding to "OK ", or turn
the froth adjustment dial to one of the milk
positions.