Instruction Manual

23
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
TURN DIAL TO CLEAN POSITION
CLEAN
ESC
Milk has been delivered recently and the tubes
inside the milk container (D) must be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 20).
TURN THE MILK FROTH
ADJUSTMENT DIAL
The milk container has been inserted with
the froth adjustment dial (D1) in the "CLEAN"
position.
Turn the dial to the required froth position.
DESCALING NEEDED
PRESS OK TO START
~45MIN
ESC OK
The machine must be descaled.
Press the selector corresponding to " OK" to
start descaling or " ESC" to descale later.
The descaling procedure described in section
“13. Descaling” needs to be performed.
REPLACE WATER SOFTENER
FILTER
PRESS OK TO START
ESC OK
The water softener lter (C4) is exhausted.
Press the selector corresponding to “ OK” to
replace or remove the lter, or ESC to carry out
the procedure later. Follow the instructions in
section “15. Water softener lter”.
GENERAL ALARM. REFER TO
USER MANUAL / APP
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly,
as described in section “12. Cleaning”. If the
message is still displayed after cleaning, con-
tact a service centre.
The appliance needs descaling and/or the lter
(C4) must be replaced.
The descaling procedure described in section
“13. Descaling” needs to be performed and/
or the lter needs replacing or removing as
described in section “15. Water softener lter”.
The tubes inside the milk container (D) must
be cleaned.
Turn the froth adjustment dial (D1) to CLEAN
(g. 20).