Instruction Manual

22
18.1 Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see section “7. Turning the appliance o”) and unplugged from
the mains power supply. Never immerse the coee machine in
water.
1. Check regularly (about
once a month) that the
inside of the appliance
(accessible after removing
the drip tray, A14) is not
dirty. If necessary, remove
coee deposits with the
brush (C5) supplied and a
sponge.
2. Remove all the residues
with a vacuum cleaner
(g. 47).
18.2 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener lter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the lter (if present) and rinse with running water;
3. Replace the lter (if provided), ll the tank with fresh water
and replace the tank;
4. (Models with water softener lter only) Deliver about
100ml of hot water to reactivate the lter.
18.3 Cleaning the coee spouts
1. Clean the coee spouts
(A8) regularly with a
sponge or cloth (g. 48A);
2. Check that the holes in
the coee spouts are not
blocked. If necessary, re-
move coee deposits with
a toothpick (g. 48B).
18.4 Cleaning the pre-ground coee funnel
Check regularly (about once a month) that the pre-ground cof-
fee funnel (A4) is not blocked. If necessary, remove coee depos-
its with the brush (C5) supplied.
18.5 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “7. Turn-
ing the appliance o”);
2. Remove the water tank (A16) (g. 3);
49 50
PUSH
PUSH
3. Open the infuser door (A18) (g. 49) on the right side of
the appliance;
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 50);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Clean the infuser without using washing up liquid as it could be
damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support (g. 51), then push the PUSH symbol fully in
until it clicks into place;
51 52
47
48B
48A