Instruction Manual

26
8. "IMMERSE FILTER IN THE
WATER TANK LETTING AIR
BUBBLES ESCAPE" (g.
63): Insert the lter in the
water tank and immerse it
completely for about ten
seconds, sloping it and
pressing it lightly to ena-
ble the air bubbles to es-
cape. Press " ";
9. "INSERT FILTER INTO ITS HOUSING AND PUSH IT DOWN TO
BOTTOM": Insert the lter in the lter housing (A17) (g.
48) and press as far as it will go. Press " ";
10. "INSERT WATER TANK": Close the tank with the lid (A15),
then replace the tank in the machine.
11. "PLACE 0.5l CONTAINER UNDER SPOUTS, PRESS OK TO FILL
FILTER" (g. 8): Place the container under the hot water
spout (C6) and press " ". Delivery begins and stops
automatically.
The lter is now active and you can use the coee machine.
21.2 Replacing the lter
Replace the lter (C4) when " REPLACE WATER SOFTENER
FILTER, PRESS OK TO START" appears on the display (B1): to re-
place immediately, press " " and follow the instructions
from point 4.
To replace the lter later, press " ". The symbol
appears on the display to remind you that the lter needs
replacing.
To replace, proceed as follows:
1. Extract the tank (A16) and exhausted lter;
2. Remove the new lter from the packaging;
3. Press " " (B2) to enter the menu;
4. Press <(B10) or > (B8) until " WATER FILTER" appears on
the display;
5. Press " ";
6. " REPLACE FILTER" appears on the display;
7. Press " ";
8. Follow the operations described in the previous section
from point 5.
The lter is now active and you can use the coee machine.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
63
21.3 Removing the lter
Replace the lter (C4) when "REPLACE WATER SOFTENER FILTER,
PRESS OK TO START " appears on the display (B). To replace
the lter immediately, press " " and follow the instruc-
tions from point 3.
To replace the lter later, press " ". The sym-
bol appears on the display to remind you that the lter needs
replacing.
To use the machine without the lter, proceed as follows:
1. Extract the tank (A16) and exhausted lter;
2. Press " " (B2) to enter the menu;
3. Press <(B10) or > (B8) until " WATER FILTER" appears on
the display;
4. Press " ";
5. " REMOVE FILTER" appears on the display;
6. Press " ";
7. " CONFIRM REMOVE FILTER": press " " (or
press " " to go back to the settings menu);
8. " FILTER REMOVED": the change has been saved.
Press " " to go back to the homepage.
Please note!
After two months (see date indicator) or when the appliance has
not been used for 3 weeks, you should replace the lter even if
the message has not yet been displayed.
22. TECHNICAL DATA
Voltage: 220-240 V~ 50/60 Hz max. 10 A
Power: 1450 W
Pressure: 1.9 MPa (19 bars)
Water tank capacity: 2 l
Size LxDxH: 260x480x375 mm
Cord length: 1750 mm
Weight: 12.4 kg
Beans container capacity: 400 g
This appliance complies with European regulation no.
1935/2004 on food contact materials.
23. DISPOSING OF THE APPLIANCE
The appliance must not be disposed of with household
waste, but taken to an authorised waste separation
and recycling centre.