Instruction Manual

32
The appliance does not come on The power cord (C8) connector is not
inserted correctly.
Insert the connector as far as it will go in the
socket at the back of the appliance (g. 1) .
It is not plugged into the mains socket. Plug into the mains socket (g. 1).
The main switch (A21) is not turned on. Press the main switch (g. 2).
The infuser cannot be extracted The appliance has not been turned o
correctly
Turn the appliance o by pressing the but-
ton (A7) (section “7. Turning the appliance o”).
At the end of descaling, the appliance
requests a third rinse
During the two rinse cycles, the water
tank (A16) has not been lled to the
MAX level
Follow the instructions displayed by the appli-
ance, but rst empty the drip tray (A14) to avoid
the water overowing.
The milk does not come out of the
milk spout (D5)
The lid (D2) of the milk container (D)
is dirty
Clean the milk container lid as described in sec-
tion “10.1 Cleaning the milk container”.
The milk contains large bubbles and
squirts out of the milk spout (D5) or
there is little froth
The milk is not cold enough or is not
semi-skimmed.
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
The froth adjustment dial (D1) is incor-
rectly adjusted.
Adjust following the instructions in section
“10.2 Adjusting the amount of froth”.
The milk container lid (D2) or froth ad-
justment dial (D1) is dirty
Clean the milk container lid and froth adjust-
ment dial as described in section “10.1 Clean-
ing the milk container”.
The hot water/steam connection noz-
zle (A9) is dirty
Clean the connection nozzle as described in
section “8.1 Cleaning the hot water/steam
connection nozzle”.
The cup warmer is hot, even though it
has been disabled
A number of beverages have been pre-
pared in rapid succession
The chocolate is not suciently dense The hot chocolate powder does not
contain thickener.
Change the type of hot chocolate powder.
The highest density has not been
selected.
Select maximum density in the corresponding
screen.
Incorrect quantities of milk and hot
chocolate powder.
Respect the instructions in section “14. making
hot chocolate”.
The hot chocolate is cold or there are
lumps
The stirrer (E4) and steam spout (E3)
are not inserted correctly in the funnel
(E2).
Insert the stirrer and steam spout on the
funnel.
The instructions have not been
followed.
Pour the milk/water into the funnel (E2) rst,
followed by the hot chocolate powder.
During cleaning, there are traces of
black on the stirrer (E4)
The magnets in the stirrer attract trac-
es of iron naturally present in the hot
chocolate powder.
Clean as described in section “8.2 Cleaning the
“Mix Carafe” (E)”.