User's Manual

23
18.7 Cleaning the coee spouts
1. Clean the coee spouts (A8)
regularly with a sponge or
cloth (g. 48A);
2. Check that the holes in
the coee spouts are not
blocked. If necessary, re-
move coee deposits with
a toothpick (g. 48B).
18.8 Cleaning the pre-
ground coee funnel
Check regularly (about once a
month) that the pre-ground
coee funnel (A4) is not
blocked. If necessary, remove coee deposits with the brush (C5)
supplied.
18.9 Cleaning the infuser
The infuser (A19) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “7. Turn-
ing the appliance o”);
2. Remove the water tank (A16) (g. 3);
3. Open the infuser door (A18) (g. 49) on the right side of
the appliance;
49 50
PUSH
PUSH
4. Press the two coloured release buttons inwards and at the
same time pull the infuser outwards (g. 50);
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID  NO DISH WASHER
Clean the infuser without using washing up liquid as it could be
damaged.
6. Use the brush (C5) to remove any coee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the in-
ternal support (g. 51), then push the PUSH symbol fully in
until it clicks into place;
Please note!
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in g. 52.
51 52
8. Once inserted, make sure
the two coloured buttons
have snapped out (g. 53);
9. Close the infuser door;
10. Put the water tank back.
18.10 Cleaning
the milk container
To keep the frother ecient,
clean the milk container (D)
every two days as described
below:
1. Remove the lid (D2);
2. Remove the milk spout (D5) and intake tube (D4) (g. 54);
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (g. 54) and pull it o upwards;
54
48B
48A
53
PUSH