User's Manual
10
the surfaces of the appliance and the side and rear walls
and at least 15 cm above the coee maker.
• Water penetrating the appliance could cause damage.
• Do not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes. Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrange the power cord in such a way that it cannot be
damaged by sharp edges or contact with hot surfaces (e.g.
electric hot plates).
5.3 Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to that
indicated on the rating plate on the bottom of the appliance.
Connect the appliance to a correctly installed and eciently
earthed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
electrician.
5.4 Setting up the appliance
Please note!
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coee
in the mill. The machine is, however, guaranteed to be new.
• You should customise water hardness as soon as possible
following the instructions in section “20. Setting water
hardness”.
1. Plug the power cord (C8) connector into the socket (A20) at
the back of the appliance and connect the appliance to the
mains electricity supply (g. 1). Make sure the main switch
(A21) at the back of the appliance is pressed (g. 2);
2. "SELECT LANGUAGE": press (B10) or
(B8)
until the
ag corresponding to the required language appears on
the display (B), then press the ag;
Follow the instructions indicated on the appliance display:
3. "FILL TANK WITH FRESH WATER": remove the water tank
(A16) (g. 3), open the lid (A15) (g. 4), ll to the MAX line
(marked on the inside of the tank) with fresh water (g. 5),
close the lid and put the tank back in the appliance (g. 6);
4. "INSERT WATER SPOUT": Check that the hot water/steam
spout (C6) is inserted on the connection nozzle (A9) (g.
7) and place a container holding a minimum of 100 ml un-
derneath (g. 8);
5. "WATER CIRCUIT EMPTY PRESS OK TO START FILLING PRO-
CESS" appears on the display;
6. Press " " to conrm. The appliance delivers water
from the spout (g. 8) then goes o automatically.
The coee machine is now ready for normal use.
Please note!
• The rst time you use the appliance, you need to make 4-5
cappuccinos before it starts to give satisfactory results.
• The rst time you use the machine, the water circuit is
empty and the appliance could be very noisy. The noise
becomes less as the circuit lls.
• When making the rst 5-6 cappuccinos, it is normal to hear
the noise of boiling water. After this, the noise becomes
less.
• To improve the performance of your appliance, we recom-
mend installing a water softener lter (C4) as described
in section “21. Water softener lter”. If your model is not
provided with a lter, you can request one from De'Longhi
Customer Services.
6. TURNING THE APPLIANCE ON
Please note!
Before turning the appliance on, make sure the main switch
(A21) is pressed (g. 2).
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted. The appli-
ance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A8) and is collected in the drip tray (A14) underneath. Avoid
contact with splashes of water.
• To turn the appliance on, press the button (A7-g.
9). The message "HEATING UP UNDERWAY PLEASE WAIT"
appears on the display.
• When heating is complete, the message changes to: "RINS
ING UNDERWAY, HOT WATER FROM SPOUTS". As well as
heating the boiler, this also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the main screen (home-
page) appears.
7. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
During rinsing, a little hot water ows from the coee spouts
(A8). Avoid contact with splashes of water.
• To turn the appliance o, press the button (A7-g.
9).