Instruction Manual

25
TROUBLESHOOTING
Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM POSSIBLE CAUSE SOLUTION
The coee is not hot
The cups were not preheated. • IfEnergySavingisnotactive,leavethecupsonthe
cup warmer for at least 20 minutes for them to warm
up.
• Warmthecupsbyrinsingthemwithhotwater
(using the hot water function).
The infuser has cooled down because 2/3 minutes have
elapsed since the last coee was made.
Before making the coee, heat the infuser by performing a
rinse cycle (see the section “Tips for a hotter coee”).
A low coee temperature is set. Set a higher coee temperature in the menu.
The coee is not creamy
enough.
The coee is ground too coarsely. Turn the grinding adjustment dial one click counter clockwi-
se towards “1” while the coee mill is in operation (g. 11).
Continue one click at a time until coee delivery is satisfac-
tory. The eect is only visible after delivering 2 coees.
Wrong type of coee Use a type of coee for espresso coee machines.
The coee is delivered too
slowly or a drop at a time.
The coee is ground too nely. Turn the grinding adjustment dial one click clockwise to-
wards “7” while the coee mill is in operation (g. 11). Con-
tinue one click at a time until coee delivery is satisfactory.
The eect is only visible after delivering 2 coees.
The coee does not come out
of the spouts, but from around
the service door.
The holes in the spouts are clogged with dry coee dust. Clean the spouts with a toothpick, sponge or hard bristled
kitchen brush.
The coee guide inside the service door is blocked and
cannot swing.
Thoroughly clean the coee guide, particularly near the
hinges.
The coee is delivered too
quickly.
The coee is ground too coarsely. Turn the grinding adjustment dial one click counter clockwi-
se towards “1” while the coee mill is in operation (g.
11). Avoid turning the grinding adjustment dial excessively
otherwise when you select two cups, the coee may be de-
livered a drop at a time.
Coee does not come out of
one of the spouts.
The spouts are blocked. Clean the spouts with a toothpick
GENERAL ALARM
The inside of the appliance is very dirty. Clean the inside of the appliance thoroughly, as described in
the section “Cleaning and maintenance”.
If the message is still displayed after cleaning, contact
customer services.
EMPTY CIRCUIT
FILL CIRCUIT
alternating with...
Water delivery
PRESSOK
The water circuit is empty. PressOKtodeliverwaterfromthespoutuntilitowsout
normally.