Instruction Manual

10
B15. icon: to select the coee quantity.
Please note :
A light touch is enough to activate the icon.
Description of milk container
(page 2 - C )
C1. Lid with milk frother
C2. Froth adjustment and CLEAN dial
C3. Frothed milk spout (adjustable)
C4. Lid release buttons
C5. Milk intake tube
C6. Milk container
C7. Thermal casing
Description of hot chocolate carafe
(page 2 - D )
D1 Hot chocolate carafe lid
D2. Funnel
D3. Steam pipe
D4. Stirrer
D5. Hot chocolate carafe
D6. Funnel release button
Description of hot water/steam spout
(page 2 - E )
E1. Release button
E2. Spout
E3. Steam nozzle
E4. Cappuccino maker
Description of the accessories
(page 2 - F )
F1. Pre-ground coee and hot chocolate powder
measuring spoon
F2. Cleaning brush
F3. “Total Hardness Test” indicator paper
F4. Descaler
F5. Water softener lter
PRELIMINARY CHECKS
Checking the appliance
After removing the packaging, make sure the product is
complete and undamaged and that all accessories are present.
Do not use the appliance if it is visibly damaged.
Contact De’Longhi Customer Services.
Installing the appliance
Important!
When you install the appliance, you should respect the
following safety warnings:
• Theappliancegivesoheat.
After positioning the appliance on the worktop, leave a
space of at least 1.18 in / 3 cm between the surfaces of
the appliance and the side and rear walls and at least 5.9
in/ 15 cm above the coee maker.
• Waterinltrationcoulddamagetheapplianceandcause
electric shock.
Do not place the appliance near taps or sinks.
• Theappliancecouldbedamagedifthewateritcontains
freezes.
Do not install the appliance in a room where the
temperature could drop below freezing point.
• Arrangethepowercableinsuchawaythatitcannotbe
damaged by sharp edges or contact with hot surfaces
(e.g. electric hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Using the appliance for the rst time
Please note :
• Coeehasbeenusedtofactorytesttheapplianceandit
is therefore completely normal for there to be traces of
coee in the grinder.
The machine is, however, guaranteed to be new.
• Youshouldcustomisewaterhardnessassoonaspossible
following the instructions in the section “Setting water
hardness” (page 21).
1. Plug the appliance into the mains socket and place the
main switch on the back of the appliance in the I position
(g. 1).
You must rst choose the language (the languages scroll
through at intervals of about 3 seconds):
2. When “English” appears, press and hold the OK icon (g.
2) for a few seconds until “English set” is displayed.
Follow the instructions indicated by the appliance:
3. FILL WATER TANK!”: remove the
water tank, ll to the MAX line with
fresh water then replace in the
appliance (g. 3).