Instruction Manual

12
Install water lter (some models only)
For instructions on the water lter, see page 21.
Set time
To adjust the time on the display, proceed as follows:
Press the OK icon to select the function. Set the
hour using the symbol to increase and the
symbol to decrease, then press OK again to
conrm, then adjust the minutes. Finally press
OK to memorise the time set.
Please note!
Hold the or symbol down to run through the hours and
minutes quickly.
Auto-start
You can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coee immediately.
Please note!
• Fortheappliancetocomeonatthesettime, the time
must be set correctly.
• Tosettheauto-starttime,thehourmustrsthavebeen
set.
Press the OK icon to select the function, then
press OK again to enable.
Adjust the time as described in the previous
section and conrm with OK. The grey symbol
indicates that the function is not active.
Please note!
• When the function is active, the symbol appears
alongside the current time.
• Todisablethefunction,accessthemenuandselectthe
function as described above. “DISABLE?” is displayed.
Press OK to conrm. The symbol alongside the current
time disappears.
• Whenthemainswitchisturnedo,the“Auto-Start”set-
ting is reset.
Auto-O (Standby)
The auto-o time can be changed so that the appliance
switches o after 15 or 30 minutes, or after 1, 2 or 3 hours.
Press the OK icon to select the function. Press the
or icon to select the required time, then
press OK again to conrm.
Energy Saving
Use this function to enable or disable Energy Saving.
When enabled, the function reduces energy consumption in
compliance with European regulations.
Press the OK icon to select the function, then press
OK again to enable or disable Energy Saving.
Please note!
• When the function is active, the symbol appears
alongside the current time.
• Afew seconds may elapse betweenEnergySavingand
delivery of the rst drink.
• WhenEnergySavingisdisabled,theapplianceturnsthe
cup warmer on automatically.
Coee temperature
To modify the temperature of the water used to make the
coee, proceed as follows:
Press the OK icon to select the function. Press
the or icon to select the required
temperature, then press OK again to conrm.
Please note!
This menu item can be customised in all proles (see
“Memorising your personal prole” on page 17).
Setting water hardness
For instructions on setting water hardness, see
page 21.
Beep
This enables or disables the beep emitted by the machine each
time an icon is pressed or an accessory is inserted/removed. The
beep is active by default.
Press the OK icon to select the function. Press
OKagaintoenableordisablethebeep.Thegrey
symbol indicates that the function is not active.
Default values (reset)
This resets all menu settings and programmed quantities back
to the default values (with the exception of the language
which remains as set).
Press the OK icon to select the function. Press OK
again to conrm and reset to the default values.
Statistics
This displays statistics relating to the machine.
Press the or symbol to display the
available data: