Instruction Manual

15
pipe and stirrer are already in place. Do not exceed the
MAX level marked on the carafe. Increase or reduce the
quantity of hot chocolate powder according to taste.
• Tousewaterinsteadofmilk,followtheinstructionsfor
milk.
• Topreparehotchocolatecorrectly,rstpourthemilkor
water into the funnel, then add the hot chocolate or cocoa
powder as shown on the hot chocolate carafe lid.
5. Close the lid (g. 22).
6. Attach the carafe to the nozzle and push as far as it will go
(g. 23). The machine emits a beep (if the beep function
is enabled).
7. Press the CHOCOLATE icon (B12).
8. Select one or two cups ( - ) by pressing the
corresponding icon.
8. Press the + or - icon to select the required density:
If the hot chocolate powder used does not contain
thickener, there will be any change adjusting the density.
9. Press the CHOCOLATE icon to start making hot chocolate
(g. 24). The appliance starts mixing the drink and then
delivers steam to heat it.
Once the coee has been made, the appliance prepares for use
again. The chocolate is ready to be poured into the cup.
Danger of burns!
While making the chocolate, the carafe and lid become very
hot. Hold by the handle only to remove the carafe and pour the
chocolate.
The chocolate is ready to be poured into the cup.
Please note!
• Tointerruptmakingthechocolate,presstheCHOCOLATE
icon again or the STOP icon.
Danger of burns!
. While making the hot chocolate, it is normal for steam to
come out of the holes in the chocolate carafe lid.
• Heatingthemilkcausessplashesinsidethecarafe.Thisis
normal.
• Thehotchocolatequantityinthecupwillvaryvaryingthe
density: if you choose thick density, there will be fewer
chocolate than that contained in the cup if choosing the
other densities.
MAKING MILK DRINKS
Please note!
A few seconds may elapse between Energy Saving and delivery
of the rst drink.
Filling and attaching the milk container
1. Press the release buttons and lift the milk container lid
(g. 25).
2. Fill the milk container with a sucient quantity of milk,
not exceeding the MAX level (g. 26).
Please note!
For a richer denser froth, use skimmed or partially skimmed
milk at refrigerator temperature (about 41°F/5°C).
To avoid milk with poor froth or large bubbles, always clean
the milk lid and hot water nozzle as described in the section
“Cleaning the milk container” on page 16.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 27).
4. Attach the lid back on the milk container.
5. Attach the container to the nozzle, pushing as far as it will
go (g. 28).
6. Place a suciently large cup under the coee spouts and
frothed milk spout (g. 29). To use particularly tall cups/
glasses, lift the coee and milk spouts (g. 30).
7. Follow the instructions below for each function.
Adjusting the amount of froth
Turn the froth adjustment dial on the milk container lid to
adjust the amount of froth on the milk delivered while making
milk drinks (g. 31). Follow the tips given in the following
table:
Dial
position
Description Recommended for…
No froth CAFFELATTE /
MILK(hotmilk)
Min. froth LATTE MACCHIATO
Max. froth CAPPUCCINO /
MILK (frothed milk)
Making caelatte/cappuccino/latte macchiato/milk
1. Press the icon corresponding to the required drink.
2. After a few seconds, frothed milk is delivered from the
milk spout into the cup below. Delivery of milk stops
automatically and (if needed for the drink), coee
Thick density
Medium density
Thin density