Instruction Manual

10
5.4 Setting up the appliance
Please note :
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the Instruction for use in the “18 Setting water
hardness” section.
Proceed as described:
1. Remove the water tank (A18- g. 1), ll to the MAX line
with fresh water (g. 2) then put back in the appliance.
2. Place a container with a minimum capacity of 100 ml
under the cappuccino maker (A7) (g. 3).
3. Plug the appliance into the mains socket and press the
main switch (A15) on the side of the appliance (g. 4).
4. The icon (B12- g. 5) ashes on the touch screen.
5. Turn the steam dial to the “I” position (g. 6). Water is de-
livered from the cappuccino maker.
6. When delivery stops automatically, turn the steam dial
back to the “O” position.
The appliance goes o.
To reuse it, press the button (A5 - g. 7) again.
Please note :
• The rst time you use the appliance, you need to make 4-5
cups of coee before the appliance starts to give satisfac-
tory results.
6. TURNING THE APPLIANCE ON
Please note!
• Before turning the appliance on, make sure the main
switch (A15) is pressed (g. 4).
• Each time the appliance is turned on, it performs an auto-
matic preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this
cycle.
Danger of burns!
During rinsing, a little hot water comes out of the coee spouts
(A9) and is collected in the drip tray (A13) underneath. Avoid
contact with splashes of water.
• To turn the appliance on, press the button (A5-g.
7): the light (B3) ashes while the appliance is heating
up and performing an automatic rinse cycle. By circulating
hot water, the appliance heats both the boiler and the in-
ternal circuits.
The appliance is at temperature when the light goes o and
the coee lights come on.
7. TURNING THE APPLIANCE OFF
Whenever the coee machine is turned o after being used to
make coee, it performs an automatic rinse cycle.
Danger of burns!
Durante il risciacquo, dai beccucci dell’erogatore del caè (A9)
fuoriesce un po’ di acqua calda. Prestare Important a non venire
in contatto con spruzzi d’acqua.
• To turn the appliance o, press the button (A5- g.
7).
• The light (B3) ashes on the control panel to indicate
the appliance is going o .
Please note!
If you will not be using the appliance for some time, unplug
from the mains socket:
• rst turn the appliance o by pressing the button
(g. 7).
• Press the main switch (A15) on the side of the appliance
(g. 4).
Important!
Never press the main switch while the appliance is on.
8. SETTING WATER HARDNESS
For Instruction for use on setting water hardness, see chapter
18.
9. SETTING TEMPERATURE SECTION
If you want to modify the temperature of the water used to
make the coee (low, medium, high, maximum), proceed as
follows:
1. With the appliance o (standby), but the main switch
(A15) pressed (g. 4).
2. Press and hold the icon (B2) until the lights and icons
on the touch screen (B) come on.
3. Press the icon (B13) to select the required
temperature:
low
medium
high
maximum
4. Press the icon (B12) to conrm (or (B10) to exit
without making the modication). The lights/icons go o.
The temperature is now programmed.