Instruction Manual

13
3. Open the pre-ground coee funnel lid (A2).
4. Make sure the funnel (A4) is not blocked, then add one
level measure of pre-ground coee (g. 13).
5. Place a cup under the coee spouts (A9 - g. 10).
6. Press the 1 cup coee icon (B2).
7. Preparation begins.
Please note!
If “Energy Saving” mode is active, you may have to wait a few
seconds before the rst coee is delivered.
13.7 Making DOPPIO+ coee using coee beans
Prepare the appliance following the instructions in the section
“13.5 Making coee using coee beans”, then press the icon
(B15).
13.8 Customising the DOPPIO+ coee quantity
The appliance is set by default to deliver about 120 ml of DOP-
PIO+ coee. To modify these settings, proceed as follows:
1. Place a suciently large cup or glass under the coee
spouts (A9).
2. Press and hold the icon (B15) until the icon ashes
and all the alarm lights ash 4 times(g. 14).
3. Release the icon. The appliance starts delivering
coee.
4. As soon as the coee in the cup reaches the required level,
press the icon again .
The quantity of coee in the cup has now been programmed.
Please note!
You can programme a minimum quantity of about 80ml.
You can programme a maximum quantity of about 160ml.
13.9 Making LONG coee using coee beans
Prepare the appliance following the instructions in the section
“13.5Making coee using coee beans”, then press the icon
(B13).
13.10 Making LONG coee using pre-ground coee
1. Follow the instructions in points 1, 2, 3 and 4 of the section
“13.6Making coee using pre-ground coee”, then press
the icon (B13).
2. The appliance starts delivering coee. Halfway through
preparation, the light (B6) comes on and the light
(B4) and icon ash.
3. Place the pre-ground coee in the funnel (A4).
4. Press the icon . Preparation resumes.
13.11 Customising the “LONG coee” quantity
The appliance is set by default to automatically deliver about
180ml of LONG coee. To modify these settings, proceed as
follows:
1. Place a suciently large cup or glass under the coee
spouts (A9).
2. Press and hold the icon (B13) until the icon ashes
and all the alarm lights ash 4 times.
3. Release the icon . The appliance starts delivering
coee.
4. As soon as the coee in the cup reaches the required level,
press the icon again .
The quantity of coee in the cup has now been programmed.
14. MAKING CAPPUCCINO
Danger of burns!
During preparation steam is given o. Take care to avoid scalds.
1. When preparing cappuccino, make the coee in a large
cup.
2. Fill a container (preferably one with a handle to avoid
scalding) with about 100 grams of milk for each cappucci-
no. In choosing the size of the container, bear in mind that
the milk doubles or triples in volume.
Please note :
For a richer denser froth, use skimmed or partially skimmed
milk at refrigerator temperature (about 5°C). To avoid milk
with poor froth or large bubbles, always clean the cappuc-
cino maker as described in the section “14.1Cleaning the
cappuccino maker after use”.
3. The cappuccino maker (A7) can be turned slightly out-
wards to allow containers of any size to be used.
4. Immerse the cappuccino maker in the milk container.
Never immerse the black ring.
5. Press the icon (B12). The light (B3) ashes to indi-
cate the appliance is heating up.
6. When the appliance is at temperature, the light goes o
and the icon ashes.
7. Turn the hot water/steam dial (B1) to the I position.
For a creamier froth, rotate the container with slow move-
ments in an upward direction. (You should not discharge
steam for more than 3 minutes at a time).
8. When you have obtained the required froth, stop steam
delivery by turning the dial to the “O” position. The icon
ashes.
9. Press the icon to exit the steam function .
Danger of burns!
Interrupt steam delivery before removing the container with the
frothed milk to avoid burns caused by splashes of boiling milk.