User Manual

9
A13. Drip tray
A14. Coee grounds container
A15. Main switch (ON/OFF)
A16. Infuser door
A17. Infuser
A18. Water tank
A19. Water softener lter housing
A20. Water tank lid
A21. Grinding adjustment dial
A22. Power cord
Description of the touch screen
(page 2 - B )
A number of icons on the touch screen have a double function. This
is indicated in brackets in the description.
B1. Steam/hot water dial
B2. icon: to make 1 cup of short espresso coee
B3.
ashing light: the appliance is heating up
B4.
light:
- on steadily: put the grounds container back (A15)
- ashing: the grounds container needs emptying
B5.
light: ll the water tank (A18)
B6.
light: general alarm
B7.
light ashing: the appliance needs descaling
B8.
icon: makes 2 cups of long espresso coee
B9. Coee taste selection dial
B10.
icon: performs a rinse cycle (when in the settings
menu: press to exit the current programming)
B11.
icon: makes 1 cup of long espresso coee
B12.
icon:
- on steadily: turns the steam function on (when in
the settings menu: press to conrm the current
programming)
- ashing: the steam/hot water dial must be turned (B1)
B13.
icon: makes one cup of LONG coee (when in the set-
tings menu: press to scroll through the various selections/
settings)
B14.
icon: to make 2 cups of short espresso coee
B15.
icon: to make one DOPPIO+ coee
Description of the accessories
(page 2 - C )
C1. Pre-ground coee measure
C2. Cleaning brush
C3. Water softener lter (*certain models only)
C4. “Total Hardness Test” indicator paper
C5. Descaler
BEFORE USE
Checking the appliance
After removing the packaging, make sure the product is com-
plete and undamaged and that all accessories are present. Do
not use the appliance if it is visibly damaged. Contact De’Longhi
Customer Services.
Installing the appliance
Important!
When you install the appliance, you should respect the follow-
ing safety warnings:
• The appliance gives o heat. After positioning the appli-
ance on the worktop, leave a space of at least 3 cm be-
tween the surfaces of the appliance and the side and rear
walls and at least 15 cm above the appliance.
• Water penetrating the coee machine could cause dam-
age. Do not place the appliance near taps or sinks.
• The appliance could be damaged if the water it contains
freezes.
Do not install the appliance in a room where the tempera-
ture could drop below freezing point.
• Arrange the cord in such a way that it cannot be damaged
by sharp edges or contact with hot surfaces (e.g. electric
hot plates).
Connecting the appliance
Important!
Check that the mains power supply voltage corresponds to
the value indicated on the rating plate on the bottom of the
appliance.
Connect the appliance to an eciently earthed and correctly
installed socket with a minimum current rating of 10A only.
If the power socket does not match the plug on the appliance,
have the socket replaced with a suitable type by a qualied
professional.
Setting up the appliance
Please note :
• Coee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of cof-
fee in the mill. The machine is, however, guaranteed to be
new.
• You should customise water hardness as soon as possible
following the instructions in the section “Setting water
hardness” on page 17.
Proceed as described:
1. Remove the water tank (g. 1), ll to the MAX line with
fresh water (g. 2) then put back in the appliance.