instructions Electric deep fryer FRP
Description of appliance The following terms are used throughout the instruction manual Basket handle Handle slide Basket Filter cover Lid Viewing window Hole for checking filter Bowl Lid release button Thermostat knob Cord storage Indicator light Handle for lifting up the appliance Foot Electric deep fryer FRP 2
Thank you for choosing this electric deep fryer.To get the best results from your deep fryer it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and maximum safety. Installation • • • • • • • Before use, check that the appliance has not been damaged during transport. Remove the appliance from the packaging, including any p.o.s. Before use, check that the power supply voltage corresponds to the value shown on the appliance rating plate.
Starting to fry 1. Put the food which is to be fried into the basket, without ever overfilling it (max. 1 kg. of fresh potatoes). In order to obtain a more even frying, we recommend concentrating the food especially around the perimeter of the basket., leaving the central part more sparingly filled. 2. Put the basket into the boiler pan in a raised position (fig.3) and close the lid by pressing lightly down upon it until the hooks click.
by the arrow (fig. 6) right front edge of the tank. 2. Remove any deposits from the tank using a sponge or absorbent paper. 3. Put the basket back in the high position and place one of the filters supplied at the bottom of the basket (fig. 7).You can obtain the filters from your retailer or one of our service centres. 4. Next pour the oil or fat very slowly into the deep fryer so that it does not spill out of the filter (fig. 8). 5.
Cleaning Before cleaning, always remove the plug from the electrical socket. Never immerse the deep fryer in water or hold it under the tap. By getting inside the water would cause short circuiting. Check that the oil is sufficiently cold (wait about 2 hours), then empty out the oil or fat as previously described in the paragraph headed “filtering the oil or fat”. Remove the lid as shown in fig. 5. The lid is removable, to take it off, proceed as follows: push the lid back (see arrow "1" fig.
• • must be set lower than the temperature indicated to avoid the oil boiling too violently. Check that the food is thinly sliced and of even thickness, as food which is too thick cooks badly on the inside, despite looking nice, while food of an even thickness reaches the ideal cooking point all at the same time. Dry the food completely before immersing it in the oil or fat, as wet food becomes soggy after cooking (especially potatoes).
Frying frozen food • Frozen foods have very low temperatures. As a result they inevitably cause a considerable drop in the temperature of the oil or fat.To achieve a good result, we advise you not to exceed the quantities recommended in the following table. • Frozen foods are often covered in ice crystals which it is necessary to remove before cooking by shaking the basket. Then immerse the basket very slowly into the frying oil to avoid the oil reboiling.
Problem solving Fault Bad smell Cause Remedy The odour-eater filter is saturated. Replace the filter. The oil has deteriorated. Replace the oil or fat. The cooking liquid is unsuitable. Use a good peanut oil. The oil has deteriorated and causes too much foam. Replace the oil or fat. You have immersed food which is not sufficiently dry in the hot oil. Dry the food well. The basket has been immersed too quickly. Immerse it slowly. The oil level in the deep fryer is over the maximum limit.
Safety warnings • • • • • • • • • • • • • • • • Before use check that the voltage power supply corresponds to the one shown on the appliance data plate. Only connect the appliance to electrical sockets which have a minimum load of 10A and which are properly earthed. (If the socket and the plug on the appliance should prove incompatible, get a professionally qualified technician to replace the socket with a more suitable one). Do not place the appliance near heat sources.
Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company.The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
5725115700/04.