manual

8
Position the steam regulator E on the dry position. Rotate the
thermostat knob
I clockwise as far as it will go (maximum
steam position). When the indicator light
H goes off, place the
iron in a vertical position and move it near the garment. Press
the super steam button (
F) until the indicator light H comes
on again. Wait until the light goes off before continuing verti-
cal ironing.
Never direct the "vertical" steam jet at a garment hanging in
a wardrobe or worn by a person. Vertical ironing should
always be carried out with the garment hanging on a clothes
stand and always away from other garments, elements,
people and animals.
SPRAY
If during ironing, you note particularly resistant creases or if
your garment requires a higher level of dampness, you can
use the spray. Make sure the tank contains water. Press the
spray button (
G) repeatedly, directing the spray jet towards
the parts of the garment to be dampened.
Never use the spray when ironing silk as the drops of water
could mark the fabric.
AFTER IRONING
To extend the working life of the iron, whenever you finish
ironing, you are recommended to empty the tank as follows:
• Unplug from the mains socket.
• Open the cover and empty the iron, holding it point
downwards and shaking it gently over a basin or sink.
. •To dry the remaining moisture, turn the iron on again with
the thermostat in the maximum position for about two minu-
tes with the steam regulator in the position.
• Unplug from the mains socket and allow to cool.
• Clean the plate with a dry cloth as traces of moisture
could mark it.