instructions ELECTRIC CONVECTOR HEATER HCM Series
Description of Appliance The following terms are used throughout the instruction manual A Thermostat Knob B Switches (certain models only) Fig. 1 I II Brackets Fig. 3 Fig.
Thank you for choosing this De’Longhi convector. To get the best results from your new heater please read these instructions carefully before use. This should ensure optimum results and maximum safety. SAFETY WARNINGS Important: to avoid the safety system resetting accidentally, this appliance must not be powered through an external timer. • The first time you use the appliance, operate it for at least 15 minutes with the thermostat at maximum to eliminate the “new” smell.
Important information for correct disposal of the product in accordance with EC Directive 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service.
Wall-mounting IMPORTANT: Before drilling into any wall ensure no electrical cables are present in the area. In order to wall mount your convector please proceed as follows: 1. Fix two brackets “C” following carefully the dimensions as indicated in description (fig. 3). Use a 6 mm masonry drill and suitable wall plugs and appropriate two screws and two brackets (provided). 2.
Important - UK only • • • The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. The appliance must be protected by a 13A approved (BS1362) fuse. warning: this appliance must be earthed. Note: • • • For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained.
5711310031/04.
