Instruction Manual
6
hours left before the appliance goes on-standby. Change the
hours using the + and - buttons, then wait a few seconds for the
program to be stored.
The current settings and symbol are displayed.
At the end of the set time the appliance switches on-standby
automatically. To go back to operating without the timer, press
the timer button twice.
The timer symbol disappears from the display.
Note: the time is settable from 0.5 to 24 hours.
Changing of the temperature scale
The display can show the temperature in both °F (Fahrenheit)
and °C (Celsius). To select the desired temperature scale, when
the unit is in standby position, press and hold the "+" key for at
least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
MAINTENANCE
Before carrying out any maintenance, unplug the heater from
the mains and wait for it to cool o completely. This heater
requires no particular maintenance. It is sucient to remove
the dust with a soft, dry cloth. Never use abrasive powders or
solvents. If necessary remove concentrated areas of dirt with a
vacuum cleaner.
TECHNICAL CHARACTERISTICS
Power supply See rating label
Absorbed power “
PROBLEM CAUSE SOLUTION
The appliance doesn't work
The appliance doesn't work
(the display could blink
and you could hear an
intermittent "beep")
The display shows a
blinking dot and you hear an
intermittend "beep"
The display shows "PF"
The display shows "Ht"
blincking (the heating
power will progressively and
automatically be reduced)
Be sure it is plugged in and that the electrical
outlet is working
The temperature may be set too low
The Key lock may be activated
The timer is not correctly programmed
The air intake or outlet grille is obstructed
The appliance could be tipped over or is positioned
in an improper way
The temperature sensor is malfunctioning
The internal temperature is too high
Plug into the power outlet
Set the temperature to a higher position
See the section "Key lock"
Program the timer correctly
Remove the obstruction remove the plug
from the mains and let the appliance cool
down. After few minutes plug the appliance
again. If the appliance doesn't work please
contact a Customer Experience
Make sure the appliance is standing upright
on a at surface. Position the appliance
correctly
Contact the nearest customer service
To remove the cause of this alarm check
that the unit is not covered or obstructed.
The appliance will operate again after few
minutes.
Check the appliance is correctly positioned
respecting the minum distances from the
wall, or objects, as indicated on the rating
label, if not, position the appliance correctly.
The appliance will operate again after few
minutes.
TROUBLESHOOTING