5711310281/03.14_00 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.
HCX Series CONVECTOR Instructions for use
DESCRIPTION B Fig. 1 B Fig. 2 B A B A Fig.
IMPORTANT WARNINGS Safety warnings Important! - - To avoid risk of cable overheating, extension leads must not be used in powering this appliance. - This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
- - - - to avoid obstruction to the air intake grille located under it. Do not obstruct the hot air outlet grilles or the air intake grille on the bottom of the appliance. Position the appliance so that the plug and the outlet can be easily reached even after installation. Do not use the appliance in rooms less than 4 m2 in area. A tip over safety device turns the appliance off if it falls over or is positioned inappropriately in such a way as to jeopardise safety.
Electrical connection - Before connecting the appliance to the current outlet, check that the voltage indicated on the appliance rating plate is the same as your electric plant and that it can stand the power consumption (Watt) indicated by the labelling. - If more than one appliance is used at once, it is important to ensure that the electric plant is able to support the power required. 4. Hang the appliance on the bracket. 5. Mark out the 2 lower fixing points.
Delayed stop: with the appliance on, press the timer button . The symbol is displayed flashing together with the hours left before the appliance goes on-standby. Change the hours using the + and - buttons, then wait a few seconds for the program to be stored. The current settings and symbol are displayed. At the end of the set time the appliance switches on-standby automatically. To go back to operating without the timer, press the timer button twice. The timer symbol disappears from the display.
TROUBLESHOOTING PROBLEM The appliance doesn't work CAUSE SOLUTION Be sure it is plugged in and that the electrical Plug into the power outlet outlet is working The temperature may be set too low Set the temperature higher The Key lock may be activated See the section "Key lock" The timer is not correctly programmed Program the timer correctly The appliance doesn't work The air intake or outlet grille is obstructed (the display could blink and you could hear an intermittent "beep") Remove the obstr
ELECTRICAL REQUIREMENTS A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead and an appropriate plug fitted, as below. With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362.