User Manual

5
x the lower part of the appliance with the 2 remaining
screws C.
USE
Operation and use
1. Plug into the mains socket.
2. The appliance emits a beep. The indicator light comes on
and remains lit while the appliance is powered.
3. The appliance switches to stand-by. A dot ashing on the
display means the tip over device has been activated. See
paragraph: “troubleshooting”.
4. Press the ON/STAND-BY to turn the appliance on. It begins
heating the room according to the current settings.
5. Press the MODE button to select one of the following
operating modes:
Freeze prevention
Heating 1
Heating 2
Heating 3
Heating 3 + Fan
5.1 Freeze prevention
In this mode, the appliance keeps the room at a
temperature of 7°C to avoid freezing.
5.2 Heating 1, 2, 3 and Heating 3 + Fan
In this mode, the desired temperature can be selected
by pressing the adjustment buttons + and –. By
pushing the + or - button once, the temperature
(shown on the display) will increase or decrease by
1°C.
Heating 1
The appliance operates at low power.
Heating 2
The appliance operates at medium power.
Heating 3
The appliance operates at high power.
Heating 3 + Fan
The appliance operates at the maximum power with
the fan.
The setting temperature range available is from 16°C
to 32°C.
6. “ECO plus” function
The “ECO plus” function is available in Heating 1, 2 3 and 3 +
fan modes only.
To activate the function, press the “ECO plus” button.
When this function is active the appliance automatically sets the
most appropriate power level to guarantee optimum comfort
while reducing energy consumption.
While the “ECO plus” function is active, the appliance may switch
automatically to a lower heating power than the one displayed.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
YELLOW: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
absent: the unit is not heating.
Brightness of the display
The appliance allows two dierent brightness settings for the
display. The highest is active when any key button is pressed.
After a few seconds of keyboard inactivity, the brightness will
decrease to the operating brightness level.
Key lock
In order to avoid accidental operation, you can lock the keyboard
using the keylock function.
To activate this function press buttons + and - together for at
least 3 seconds. The display shows the symbol and a double
acoustic signal will be emitted. To deactivate the function
proceed in the same way.
Timer function
This function can be activated in two dierent ways.
Delayed start: With the appliance on-standby, press the timer
button (F) .
The symbol is displayed ashing together with the hours left
before the appliance comes on.
Change the hours using the + and - buttons, then wait a few
seconds for the program to be stored.
The display will return to o and the symbols remains on.
When the programmed time has elapsed, the appliance will
come on with the previous settings.
Delayed stop: with the appliance on, press the timer button
. The symbol is displayed ashing together with the
hours left before the appliance goes on-standby. Change the
hours using the + and - buttons, then wait a few seconds for the
program to be stored.
The current settings and symbol are displayed.