5711413781_01_0419 De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.
HFX65 Series CERAMIC FAN HEATER Instructions for use This product is only suitable for well insulated spaces or occasional use
G I D B E F C A A D E F B C H 2
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or Danger! perform user maintenance. Failure to observe the warning may result in life threatening CAUTION — Some parts of this injury by electric shock. product can become very hot and - The appliance must not be placed imcause burns. Particular attention mediately under a fixed power socket.
not at all). To reset, unplug the appliance from the mains socket for a few minutes, remove the cause of overheating then plug in again. If the appliance doesn’t work please contact the De’Longhi Customer Service. - Tip over safety device: Certain models are fitted with a tip-over switch which turns the appliance off if it falls over. To restart the appliance, simply place it upright again. dry. Do not obstruct the air intake and outlet area (danger of overheating). - The appliance must not be hung.
DESCRIPTION A B C D E F G H I - ON/STAND-BY button +/- Adjustment buttons Oscillation button “ECO PLUS” function button Timer button MODE button (for selecting the operating mode) Power indicator light Back cover with filter Receiver for remote control (certain models only) Please note: The display can show the temperature in both °C and °F. To change the temperature scale, press and hold the + key for few seconds, then release.
Inserting or replacing the batteries - The remote control is provided with a lithium battery CR2032. To let the appliance function, remove the battery cover strip, by pulling it. - To replace the batteries, remove the battery cover by rotating it. Fig. 1 Replace the battery paying attention to respect the right polarity as shown in figure 1. - Replace the cover rotating it towards the position .
TROUBLESHOOTING PROBLEM CAUSE SOLUTION PF display and emits a beep Temperature sensor is not working Please contact Customer Service properly Product doesn’t turn on Check that the plug is connected to the Plug in outlet Auto-start is on Wait till time elapsed or press the button (E) twice to cancel the auto-start and push the button (A) Room temperature reaches the set Use the “+” button to increase the set temperature temperature The appliance goes off unexpectedly Check that the plug is connecte
