Instruction Manual

7
PROBLEM CAUSE SOLUTION
The appliance doesn’t
work
The plug is not inserted properly into the pow-
er socket or the socket switch is o.
Check for any obstruction.
The switches are pressed to OFF.
The thermostat is set too low.
Insert the plug into the power socket and
switch on if necessary.
Remove the obstruction, disconnect the
power plug of the heater and let the ap-
pliance cool down. If the problem per-
sists, contact your nearest service centre.
Press the switches to positions MIN, MED ,
MAX .
Turn the thermostat knob clockwise to higher
settings until the heater restarts.
TROUBLESHOOTING