instructions Coffee Maker ICM8/18
escription of the appliance Coffee Maker EC190/200
Electrical requirements Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
SAFETY WARNINGS • This machine is designed to “make coffee” and to “heat drinks”: be careful to avoid scalding from the water and steam jets or by using the machine incorrectly. • Do not touch hot parts (steam and hot water tube, boiler outlet, areas in contact with the filter holder and the warming plate). • After having removed the packaging, make sure that the product is complete. If in doubt, do not use the appliance and contact qualified personnel only. • This appliance is for home use only.
CHLORINE FILTER (if fitted) The filter eliminates the taste of chlorine from the water.To install the filter, proceed as follows : • Remove the chlorine filter from the plastic bag and rinse it in tap water. • Lift the coffee lid, remove the filter holder from its housing by lifting it upwards (Fig. 1). ig. 1 • Open the filter holder by pressing the parts marked “PUSH”, and carefully position the filter as shown in Fig. 2. • Close the filter holder and replace it in its housing, pushing it fully down.
ig. 8 ig. 9 ig. 10 • Place the ground coffee in the filter, using the measuring spoon supplied, and level evenly (Fig. 8). As a general rule, use a level measuring spoon of ground coffee (around 7 grams) for each cup (for example, 12 spoons to make 12 cups).The quantity of ground coffee used may, however, be varied according to personal taste. Use good quality, medium ground coffee, packaged for drip coffee makers.
CLEANING AND MAINTENANCE Before performing any cleaning or maintenance operations, turn the machine off, unplug it from the power socket and allow it to cool down. 1. When cleaning the coffee maker, do not use solvents or abrasive detergents. A soft, damp cloth is sufficient. 2. Never immerse the coffee maker in water: it is an electrical appliance. ig.
TROUBLESHOOTING Problem Probable cause The drip coffee The drip coffee takes longer to per- maker needs to be colate descaled The coffee has a vinegary taste Coffee Maker EC190/200 The coffee maker has not been rinsed sufficiently Solution Perform the descaling procedure as described in the paragraph “Descaling” Rinse the appliance as described in the chapter “Descaling”