Instruction Manual

6
TM
appliance from the mains electrical supply. Make sure
that your hands are clean and free from soap, cream or
anything which might taint the water.
- Empty the kettle and remove the lter as shown in g.
1. Rinse under a tap whilst brushing with a soft brush
(g. 2) and replace the lter (g. 3). Filter may pose
suocation risk, do not let it unattended after
cleaning.
To clean the kettle and the scale lter
It is vital to clean and descale regularly in order to maintain
good working order. Excessive scale build-up may aect the
performance of the product and shall be avoided.
- Use descaler for kettles (tip: use citric-acid based
descaling solutions). When limescale starts forming
on the heating element, buy a suitable descaler for
kettles and descale according to the instructions given
on the descaler pack.
- After descaling, boil repeatedly with fresh water and
rinse thoroughly to completely eliminate all residues
of descaler which could damage the appliance. Repeat
the boil and rinse steps for at least three times.
- If the lter requires descaling, remove and immerse in
the same descaling solution.
- Make sure electric parts are completely dry before
using the kettle.
TECHNICAL CHARACTERISTICS
Supply voltage See rating plate
Absorbed power “
ELECTRICAL CONNECTION UK ONLY
A) If your appliance comes tted with a plug, it will incorporate a 13 Amp fuse. If it does not t your socket, the plug should be
cut o from the mains lead, and an appropriate plug tted, as below. WARNING: Very carefully dispose of the cut o plug
after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on
type, the fuse cover must be re-tted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event
of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not tted with a plug, please follow the instructions provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol or
coloured green or green and yellow. The blue wire must be connected to the terminal marked with the letter N or coloured black.
The brown wire must be connected to the terminal marked with the letter L or coloured red.