Technical data
13
15). Each mark on the side of the container corresponds to
100 ml of milk.
Please note!
partially skimmed milk at refrigerator temperature (about
5°C).
few seconds before the drink is delivered.
3. Make sure the milk intake tube is correctly inserted in the
bottom of the milk container lid (g. 16).
4. Place the lid back on the milk container.
5. Remove the hot water spout from the nozzle.
6. Attach the container to the nozzle, pushing as far as it will
go (g. 17).
the frothed milk spout. Adjust the length of the milk spout.
To move it nearer the cup, simply pull it downwards (g.
18).
8. Follow the instructions below for each function.
Adjusting the amount of froth
Turn the froth adjustment dial on the milk container lid to adjust
the amount of froth on the milk delivered while making cappuc-
cinos and milk-based drinks.
Dial
position
Description Recommended for…
caelatte/hot milk (without
froth)
Min. froth
Macchiato
Max. froth
MILK
Making cappuccino
1. Fill the milk container and attach it as described above.
2. Turn the froth adjustment dial on the milk container lid to
the position corresponding to the required froth.
together with a progress bar which lls gradually as prepa-
ration proceeds.
4. After a few seconds, frothed milk is delivered from the milk
spout into the cup below. For drinks with coee, the ma-
chine automatically makes the coee after delivering the
milk.
Please note!
coee in the cup, within 3 seconds, press and hold the CAP-
long periods. The warmer the milk (5°C is ideal), the poorer
the quality of froth produced.
Making frothed milk only (without coee)
Proceed as described in the previous paragraph (Making cap-
instead of once.
Please note!
If during delivery you want to stop making milk or coee, press
Making milk only (without froth or coee)
Proceed as described in the previous paragraph (Making frothed
milk only), turning the froth regulator to position.
CLEANING THE MILK CONTAINER AFTER USE
Important! Danger of burns
When cleaning the internal tubes of the milk container, a little
hot water and steam leak out of the frothed milk spout. Avoid
contact with splashes of water.
After preparing a cappuccino or milk based drink, the machi-
ne must be cleaned to remove the milk residues. Proceed as
follows:
1. Leave the milk container in the machine (you do not need
to empty it);
2. Place a cup or other recipient under the frothed milk spout.
-
ration runs and then stops automatically.
4. Turn the dial back to one of the froth selections.
5. Remove the milk container and always clean the steam
nozzle with a sponge (g. 20).
Please note!
clean the milk container after you have prepared the last
drink only.
heat up.