Technical data

14
Programming the quantity of coee and milk in
the cup for cappuccino or milk
The appliance is set by default to automatically deliver standard
quantities. To change these quantities, proceed as follows:
1. Place a cup under the coee spouts and milk spout.
 

3. Release the button. The appliance starts delivering milk.
 

5. The appliance stops delivering milk and after a few secon-

Program quantity” is displayed.
       

stops.
The machine is now reprogrammed with the new milk and cof-
fee quantities.
HOT WATER
Important! Danger of burns.

delivered. The spout becomes hot during delivery. Hold by the
handle only.
1. Make sure the hot water spout is attached correctly (g. 4).
2. Place a container under the spout (as close as possible to
avoid splashes).
3. Press the button 
together with a progress bar which lls gradually as prepa-
ration proceeds.
4. The machine delivers 250 ml of hot water, then delivery
stops automatically. To interrupt delivery of hot water ma-
nually, press the button again.
Please note!
If “Energy saving” mode is active, you may have to wait a few
seconds before the hot water is delivered.
Changing the quantity of water delivered
automatically
The machine is set by default to automatically deliver 250 ml of
hot water. To modify these quantities, proceed as follows:
1. Position a container under the spouts.
2. Press and hold the 
quantity” is displayed, then release.
3. When the hot water in the cup reaches the required level,
press the button again.
The machine is now reprogrammed with the new quantity.
CLEANING
Important!
 
the appliance. With De’Longhi superautomatic coee ma-
chines, you need not use chemical products to clean the
machine.
 
deposits as they could scratch metal or plastic surfaces.
Cleaning the coee grounds container

container must be emptied and cleaned.
Until the grounds container has been cleaned, the appliance
continues to display the message and coee cannot be made.
To clean (with the machine on):
 
 -
move all residues left on the bottom.
 
Important!
When removing the drip tray, the grounds container must be
emptied, even if it contains few grounds.
If this is not done, when you make the next coees, the grounds
container may ll up more than expected and clog the machine.
Cleaning the drip tray and condensate tray
Important!
If the drip tray is not emptied regularly, the water could over-
ow from the edge and seep inside or around the coee maker.
This could damage the machine, the surface it rests on or the
surrounding area.
The drip tray is tted with a level indicator (red) showing the
level of water it contains (g. 23).

must be emptied and cleaned.
To remove the drip tray:
1. Remove the drip tray and the grounds container (g. 24);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray and empty if necessary.
4. Replace the drip tray and grounds container.