PA C N 1 2 0 User manual
DESCRIPTION 1 2 5 3 6 7 8 9 4 10 ACCESSORIES 11 15 19 13 12 14 17 16 20 18 21
Important safeguards • Use this appliance only as described in this instruction manual. As with all electrical equipment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. • This appliance is designed for home air conditioning and must not be used for other purposes. • It is dangerous to modify or alter the characteristics of the appliance in any way.
Pre p a r i n g f o r u s e ELECTRICAL CONNECTIONS Before plugging the appliance into the mains socket, check that: • The outlet’s power supply corresponds to the value indicated on the rating label on the back of the appliance; • The outlet and electrical circuit are adequate for the appliance; • The outlet is a 3-hole grounded outlet . If this is not the case, you must choose another outlet. Failure to follow these important safety instructions absolves the manufacturer of all liability.
Pre p a r i n g f o r u s e French window 134 5,27 in. • Attach the window outlet 20 to the air exhaust hose as shown in fig. F. 2 1 in the window pane F I • Open the French window slightly and position the outlet 20 as shown in figure G G Keep the air hoses as short and free of curves as possible to avoid constrictions. in the wooden kickboard of a French window in the wall: you are recommended to insulate the section of wall using suitable insulation. • Fit the wall flange 11 into the hole.
Control panel THE CONTROL PANEL S O Q P N A B I H G T L M C R D E F DESCRIPTION OF THE CONTROL PANEL A ON/OFF button B MODE selection button Air conditioning, dehumidifying, fan.
Operation TURNING THE APPLIANCE ON Plug into an outlet. Two lines appear on the display indicating that the appliance is in stand-by. Press the ON/STAND-BY button (A). When turned on, the air conditioner starts operating in the same mode as when it was turned off.
Operation FAN MODE Adjust fan speed by pressing the FAN button (C) as described for the air-conditioning mode. Remember that the higher the speed, the more air is filtered. If you select "MIN" speed, less air is filtered but the appliance is also less noisy. DEHUMIDIFYING MODE Ideal for reducing the humidity in a room without lowering or raising the temperature (spring or autumn, damp rooms, rainy spells, etc). When the dehumidifying mode is selected, the light (P) comes on.
Using the remote control unit (some models only) MODELS WITH REMOTE CONTROL • Point the remote control at the receiver on the air conditioner. The remote control must be no more than 16,4 ft (5 metres) away from the appliance (without obstacles between the remote control and the receiver). • The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat.
Tips To get the best from your air conditioner, follow these recommendations: • close the windows and doors in the room to be air conditioned. The only exception is when the appliance is installed through a hole in the wall. In this case, you are recommended to leave a slight draught through a door or window to guarantee correct ventilation. • Never use the appliance in very damp rooms (laundries for example). • Never use the appliance outdoors.
Cleaning Before cleaning or maintenance, turn the appliance off by pressing the ON/OFF button (A) or in models with remote control unit, by pressing the ON/OFF button 22 , then always unplug the appliance from the mains socket. CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. For safety reasons, never wash the air conditioner with water. Precautions Never use petrol, alcohol or solvents to clean the appliance.
Troubleshooting NOTE: NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After the unit has been on its side, oil needs to return to the compressor to ensure proper function. Without allowing the unit this time (6-24 hours) The unit may function for only a short time, and then the compressor will break down from lack of oil.
Technical specifications TECHNICAL SPECIFICATION Power supply voltage see rating label Max. absorbed power during air conditioning “ Refrigerant “ Cooling capacity “ LIMIT CONDITIONS Room temperature for air conditioning 21 ÷ 35°C Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a technical service centre appointed by the manufacturer only. The appliance should be disposed of by a specialist centre appointed by the manufacturer only.
