Use and Care Manual

5
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take a few
moments to read the instructions to avoid risks or damage to the
appliance.
DESCRIPTION
1 air outlet grille
2 control panel
3 castor wheels
4 handles
5 lter
6 air intake grille
7 air exhaust hose housing
8 drainage hose with cap
9 power cable
10 wall ange
11 air exhaust hose
12 window outlet
13 castor locks
14 remote control
15 window bracket with locking pins
16 window bracket extension
To avoid damage to the unit
NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR
ON ITS SIDE. IF THIS OCCURS, WAIT 6 HOURS BEFORE TURNING
THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. After the unit
has been on its side, oil needs to return to the compressor to
ensure proper function. Without allowing the unit this time (6-
24 hours) the unit may function for only a short time, and then
the compressor will break down from lack of oil.
Electrical connection
Before plugging the appliance into the outlet, check that:
• The outlet’s power supply corresponds to the value
indicated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• Theoutletisa3-holegroundedoutlet . If this is not
the case, you must choose another outlet. Failure to
follow these important safety instructions absolves the
manufacturer of all liability.
it becomes necessary, the power cable must be replaced
by a qualied professional only.
The instructions below will enable you to prepare your air
conditioner for operation as eciently as possible. Before use,
make sure the air intake and outlet grilles are unobstructed.
USE
AIR CONDITIONING WITHOUT INSTALLATION
For optimal results set-up in a double-hung window:
1) Place the bracket in the window sill, extend the bracket
fully within the window frame, x the bracket by using the
pin then lower the window onto the bracket. (Should the
window bracket be too large for the window. The plastic
can be cut with a saw by a qualied professional.)
2) Fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in gure A.
3) Connect the window outlet (12) to the other end of the
exhaust hose.
4) Insert the window outlet end of the exhaust hose into the
slot of the window bracket (g. B).
Other set-up methods:
• Thankstothelockingpins,it’spossibletousethewindow
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see gure C).
• Ifyouhaveacasementwindow(gureD)followsteps2&
3 and place the window outlet (12) outside the window to
exhaust the hot air.
A
B
C