Installation Guide

ManualsBrandsDeLonghi ManualsHeating, Ventilation, and Air ConditioningPinguino N Series 13,000 BTU 115-Volt Air-to-Air Portable Air Conditioner with Heat Pump and Remote Control

Preparing for use

ELECTRICAL CONNECTIONS

        

that:

        

indicated on the rating label on the back of the appliance;

         

appliance;

 

the case, you must choose another outlet.

Failure to follow these important safety instructions

absolves the manufacturer of all liability.

The power cable must be replaced by a qualied

professional only.

         

conditioner for operation as eciently as possible. Before

use, make sure the air intake and outlet grilles are

unobstructed.

AIR-CONDITIONING WITHOUT INSTALLATION

Just a few simple steps and your comfort is ensured with your

air conditioner:

 13 to the hose’s end 12.

 

appliance. Insert it as shown in gure A.

     17 to the other end of the

exhaust hose. (see g. B).

Sash window

 

  15 in the window, extending it

to t the width of the window (g. C).

         

assembled exhaust hose 12 into the window bracket hole

15.

 

 

window aperture, use the additional window bracket

without holes extending it to the desired dimension,

then x the bracket by using the locking pin provided.

When extracting the window bracket and joining the two

pieces pay attention you do not cover the hole.

Other set-up methods:

 

bracket also for sliding windows. Position the hole of the

bracket so to allow a correct installation of the exhaust

hose (see gure D).

Keep the air hoses as short and free of curves as possible to

avoid constrictions.

Summary of content (2 pages)

PAGE 1
Preparing for use en ELECTRICAL CONNECTIONS Before plugging the appliance into the mains socket, check that: • The outlet’s power supply corresponds to the value indicated on the rating label on the back of the appliance; • The outlet and electrical circuit are adequate for the appliance; • The outlet is a 3-hole grounded outlet . If this is not the case, you must choose another outlet. Failure to follow these important safety instructions absolves the manufacturer of all liability.
PAGE 2
Preparing for use en 134 5,28 in. French window • After having screwed the window outlet 17 into the air exhaust hose 12 , open the French window slightly and position the window outlet 17 as shown in figure E. in the window pane in the wooden kickboard of a French window E • • • semi-permanent INSTALLATION If required, your appliance can also be installed semipermanently (Fig. F). • in the wall: you are recommended to insulate the section of wall using suitable insulation.