Instruction manual

18
The instructions below will enable you to prepare your air conditioner for operation as efficiently
as possible.
Before use, make sure the air intake and outlet grilles are unobstructed.
AIR CONDITIONING WITHOUT INSTALLATION
Just a few simple steps and your air conditio-
ner will ensure your comfort:
• Screw one of the hose adapters to one
end of the air exhaust hose. .
• Fit the other adapter to the air exhaust
hose housing at the back of the
appliance (see fig. A).
• Screw the end of the hose without adapter
to the adapter previously mounted on the
appliance (see fig. A).
12
7
13
13
Preparing for use
ELECTRICAL CONNECTIONS
Before plugging the appliance into the mains socket, check that:
• the mains power supply corresponds to the value indicated on the rating plate on the back of the applian-
ce;
• the power socket and mains electricity supply are adequate for the appliance;
• the mains socket matches the plug. If this is not the case, have the plug replaced;
• the mains socket is adequately earthed. Failure to follow these important safety instructions absolves the
manufacturer of all liability.
The power cable must be replaced by a qualified professional only.
A
Vertically sliding window
• Fit the bar grille to the bar and fix
with the four screws provided (fig. B).
18
17
15
DESCRIPTION
1 Air outlet grille
2 Control panel
3 Handles
4 Castors
5 Filter
6 Evaporator air intake grille
7 Air exhaust hose housing
8 Condenser air intake grille
9 Power cable
10 Drain hole bung
11 Wall flange
12 Air exhaust hose
13 Hose adapter (2 pieces)
14 Wall mounting accessory
15 Bar grille
16 Bung for hole in bar
17 Bar
18 Screws
19 Window outlet
20 Remote control
B
• Open the window.
• Place the bar
in the window and
extend it for the width of the window (fig. C).
• Once the bar has been extended, fix it by
screwing up the remaining two screws
supplied.
• Lower the window (fig. D).
17