Installation manual

SINGLE SPLIT

8 English 11/2002

OPERATING MODES

1. Selecting the operating mode

Each time that the MODE button is pressed the oper-

ating mode is changed,in the following sequence:

FULL AUTO COOLING DRY FAN ONLY

HEATING

2. FAN mode

Each time that the FAN button is pressed,the speed is

changed,in the following sequence:

AUTO LOW MEDIUM HIGH

3. Setting the temperature

Press once to increase the set temperature

by 1°C.

Press once to decrease the set temperature

by 1°C.

Range of temperature settings available:

HEATING 16°C ~ 30°C

COOLING 16°C ~ 30°C

DEHUMIDIFICATION 16°C ~ 30°C

FAN ONLY no setting allowed

4. Starting the appliance

Press the button .

When the unit is switched on it will start

operating in the mode selected prior to

being switched off.

5. Adjusting the air flow

Pressing the “SWING” button starts moving the air

flow louvers start automatically; pressing the

“SWING” button again stops the louvers.

Do not move the vertical air flow louvers

manually,as this may cause poor operation. If

this happens, first turn the appliance off, then

disconnect and reconnect it to the power

supply.

Adjusting the horizontal air flow (manual)

Turn the louver sliders for the horizontal adjustment of

the air outlet to change the angle of the air flow,as shown

(the unit illustrated may be different from the air-condi-

tioner you have purchased).

This operation must be carried out by specialist

technicians.

U I A

Sliders for adjusting the horizontal air flow louvers.