Instruction Manual

8
draught, because strong draughts of air may adversely
aect the equipment’s operational eciency.
- Only use the heater in an upright position.
- The heater must be positioned at least 50cm from
furniture or other objects.
- The rst time you use the appliance, operate it of at
least 15 minutes with the thermostat at maximum to
eliminate the “new” smell. A little smoke due to the
protective substances applied to the heating element
before transport may be given o.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet
can be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in area.
- The appliance is tted with a safety device which will
switch o it in case of accidental overheating. To reset,
please contact Customer Experience, see enclosed
guarantee.
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste se-
paration and recycling centre.
DESCRIPTION
A Thermostat
B Power selector
C/D/E Power indicator lights (MIN, MED, MAX)
F Cord holder
G Wheel
USE
Fitting the wheels
Turn the radiator upside down on a rug or soft surface to
prevent damaging the paint nish. Fully unfold the wheels
by turning them outwards (Fig. 1). Turn the radiator back to
its upright position.
Caution
Always operate the heater in upright position only (wheels
on the bottom, controls on top).
Any other position could create a hazardous situation.
Location
The heater should not be placed immediately below a power
outlet. Do not use this radiator in rooms with a oor area of
less than 4 m
2
(43 sq. ft. ).
Connection
- Before using the appliance check that your supply
voltage is the same of that shown on the rating label
of the unit and that the power socket and power supply
line correspond to the load specied.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
Keep loose clothing or bedding, furniture and ammable
material away from the heater's wall outlet.
Turning on
Insert the plug into an electrical outlet, rotate the thermostat
dial to maximum and turn the unit on as follows using the
power selector:
- Turn the power selector to position MIN to select
minimum output (the min light will be on).
- Turn the power selector to position MED to select
medium output (the min/med lights will be on).
- Turn the power selector to position MAX to select
maximum output (the lights will be on).
Adjusting the thermostat
When the room has reached the desired temperature, turn
the thermostat dial slowly in an anti-clockwise direction until
you hear a "click" and not beyond it.
The thermostat will then adjust the set temperature
automatically and keep it constant. If your unit is a three-
output version, in intermediate seasons or on days when
temperatures are not particularly cold, select minimum
output to optimize savings and consumption.
Antifreeze function
Turn the thermostat dial to the position and the power
selector to position MAX.
The appliance will maintain a minimum room temperature
of approximately 5°C, thus preventing freezing while
conserving energy. In models that come with a timer, teeth
must be set in the inward position.
Reminder
To completely shut the appliance o, turn the power selector
to the "0" position and then unplug the appliance from the
outlet.